Installation guide

6
Remote
Starting
Your
Vehicle
To
activate the remote start function, press and release the
0
button 2 times within
2 seconds. The system
will sound, the parking lights
will flash 1 time and the
system
will
check the vehicle to ensure it is safe to start.
If all
safety parameters
are correct, the vehicle will
start within 5 seconds. The vehicle's parking lights
will
turn on (or flash depending on system settings) as a visual indication that the
vehicle has started and is running.
If your vehicle stalls or does not start, the system will
pause 5 seconds, then try 2
more times to start the vehicle (a total of 3 attempts). The system
will pause 5
seconds between each start attempt. If
the vehicle does not start after the 3rd
attempt, the system
will abort the remote vehicle start process.
Note: Do not leave children or animals unattended
in
the vehicle when using the
remote start feature.
Note: Manual transmission vehicles - Remote
Start
Ready Mode must be set.
Remote
Start
Shutdown
Press and hold the
0
button for 3 seconds to turn the vehicle off.
Entering
the
Vehicle
while
it
is
Running
via
Remote
Vehicle
Start
1.
Unlock the vehicle's doors.
2.
Enter the vehicle.
DO
NOT PRESS THE BRAKE PEDAL!
3.
Insert the key into the ignition switch and turn to the
ON
or RUN
position.
4.
Press the brake pedal. The remote vehicle starter will disengage and
the vehicle
will
operate normally.
Preheating
or
Precooling
the
Vehicle's
interior
Before exiting the vehicle, set the temperature controls to the desired setting and
operation. After the system starts the vehicle, the heater or air conditioner will
activate and heat or cool the vehicle's interior to your setting.
User
Programmable
Run
Time
I
Run
Time
Extension
The system has the ability to allow
the user to extend the time the vehicle
will
be
running under control of the remote start. This
will
only extend the run time back to
the current run time setting during the current remote start
cycle. If
your system is
set to run 15 minutes and the time remaining is 4 minutes, extending the run time
will
reset the countdown timer to 15 minutes and your vehicle
will
continue to run
for another 15 minutes.
Follow
the steps below to extend the vehicle's run time.
1.
The remote start must already
be
active.
2.
Press and release the
0
button 4 times.
3.
The system
will
chirp 1 time and flash the parking lights 4 times to
confirm that the run time has been reset.
ca5153/5153sst rev A