Installation guide
Using Your Remote Starter
Remote
Start
Ready
Mode
must
be
enabled
if
your
vehicle
is
equipped
with
a
manual
transmission.
Remote
Start
Ready
Mode
-
Manual
Transmission
Vehicles
Only
To
activate the remote start function, the system must first
be
in
Remote Start
Ready Mode. Follow the steps below to enter remote start ready mode.
1.
While the engine is running by the ignition key;
a.
Set the parking brake
b.
Place the transmission
in
neutral.
2.
With your foot off the brake pedal, press and release the 0 button 2
times within 2 seconds. The LED will flash 3 times and the parking
lights will turn
on
to confirm the system has entered quick stop mode.
3.
Remove the keys from the ignition, the vehicle will remain running
in
quick stop mode.
4.
Exit the vehicle and close all vehicle doors.
5.
Within 1 minute of step
1,
press the
(2)
button to lock the vehicle's
doors. The vehicle will shutdown and sound 1 short chirp then 1 long
chirp to confirm ready mode is set.
Cancelling
Remote
Start
Ready
Mode
The system will exit remote start ready mode if any of the following occur:
Open any door
Open the hood or trunk (if connected)
Press the brake
Release the parking brake
Turn the ignition
ON
2012 Audiovox Electronics Corporation.
All
rights reserved.
5