Installation guide
Additional
:Ports
Antenna
I
LED
I
Programming Port
Mount the supplied antenna/receiver to a
clear spot
on
the vehicle's windshield
that
will
not block the driver's vision. A good location is
usually
high
on
the
windshield
near the rear view mirror.
Be
careful
not to mount the antenna/receiver
on any
metallic window
film,
as this
will
effect system range. Route the antenna/
receiver
cable
to the
control module
and plug
into the antenna port.
Data Bus
Interface Port
This 4 pin port is used for
Flashlogic Door Lock and Transponder Databus
Interfaces to communicate with the vehicle's Databus. When using the
OBI
port to
control
the
Flashlogic
Door Lock and Transponder Interface
modules
the
following
options may be
available. Please
refer to the
020
(Data to Data)
function
list available per
vehicle
on
the tech service web site.
Tach
Input
Brake Safety Shut Down
Trunk/Hatch
Open Diesel Glow Plug Input
Door Lock Control Passlock
I
Passkey Interface (GM Only)
Dome Light Supervision Transponder Interface
Activation
Factory
Alarm
Arm
I
Disarm
Manual
Arm
I
Disarm Inputs (factory
keyless
controls
system)
Telematic Interface Port
This 4 pin port is used for Telematic
Interface
accessories, such as CarLink,
which can
control some of the
following
features.
Door Lock
Control
Trunk
Release
Sliding
Doors AUX
Output
Car Find Remote Start
2012
Audiovox Electronics Corporation.
All
rights reserved. 1 5