Installation guide
3
LTBLUE
FACTORY ARM
I
PULSE
AFTER
START
(-)
This wire will supply a
(-)
500mA
pulse both upon arming the system and upon
successful completion of the remote start activation sequence and is
typically
used to re-lock the vehicle's doors upon remote start if necessary.
This output is configurable
in
option programming.
4
LT
GREEN/BLACK
FACTORY DISARM
I
PULSE BEFORE
START
(-)
This wire
will supply
a ( - ) 500mA pulse
both upon disarming the system and when
the remote start feature is activated. Locate the factory perimeter
alarm
disarm
wire from the key
cylinder
inside the drivers door.
Verification:
This wire registers ground if the key is turned to the
unlock
position in the driver's door cylinder.
This output is configurable
in
option programming.
2 Pin Door
...
Lock Harness
1
BLUE
UNLOCK
(-)
2
GREEN
LOCK
(-)
The door
lock I unlock outputs are designed to control
several
different types of
systems which may require additional parts.
Please
review the wire and
location
chart to see which type of door lock system is
in
your vehicle. The most common
types are shown
in
the following
diagrams.
2012 Audiovox Electronics Corporation.
All
rights reserved.
11