Owner's Manual

8
Additional 2-Way LCD Remote Control Functions
Check Vehicle Status
Press and release [F 2 times then press @ within 3 seconds, the transmitter will
display the current status
of the vehicle.
Display Illumination
Press and hold the [F button for 1 second. The display will illuminate for 5 seconds.
Melody I Vibration Mode
To have the remote control vibrate, play a melody tone or both each time it receives a
response from the vehicle press and release
[F then press and hold ~ for 2
seconds.
Button Beeps
To toggle button beeps on or off press and release [F then press and hold tJ for 2
seconds.
Battery Save Mode
While in POWER SAVE MODE the 2-way LCD transmitter will NOT look for any
incoming signals from the main unit until a button is pressed. The LCD screen will
display SAVE to indicate that power save mode is ON.
To enter power save mode
press and hold
rF for 5 seconds.
Clear Flashing Icons and Melody Sound
Press the [F button 3 times within 3 seconds. This will clear the melody sound and
flashing icons on the LCD screen.
Stopping LCD Trigger Melody
To stop the alarm trigger melody if the system has been triggered WITHOUT
disarming the system, press any button one time only, this will not send a command to
the vehicle at this time and the alarm will continue to sound.
ca1554 rev A