Owner's Manual

14
Additional Ports
Antenna I LED I Programming Port
Mount the supplied antenna/receiver to a clear spot on the vehicle's windshield that
will not block the driver's vision. A good location is usually high on the windshield
near the rear view mirror. Be careful not to mount the antenna/receiver on any
metallic window film, as this will effect system range. Route the antenna/receiver
cable to the control module and plug into the antenna port.
Data Bus Interface Port
This 4 pin port is used for Flash logic Door Lock and Transponder Databus Interfaces
to communicate with the vehicle's Databus. When using the
OBI port to control the
Flashlogic Door Lock and Transponder Interface modules the following options may
be available. Please refer to the D2D (Data to Data) function list available per vehicle
on the tech service web site.
Door Trigger
Trunk/Hatch Open
Dome Light Supervision
Door Lock Control
Factory Alarm Arm
I Disarm
Manual Arm
I Disarm Inputs (factory keyless controls system)
ca1554 revA