Owner's Manual
Table Of Contents
Using Your Remote Control
Arming the Security System
To
arm the system,
exit
the vehicle, close all doors, then press the
$;
button.
The
parking lights will flash 2 times, indicating the system is armed,
has
locked the
doors (if
equipped
and
connected)
and activated the starter
disable
feature.
The
LED status indicator will blink steadily, once per second.
NOTE:
The
system is
defaulted
with Silent Choice enabled,
which
requires a
second press
of
the 9 button to activate an
audible
arming
response
from the
vehicle.
Bypassing The Shock Sensor
To arm the system and
ignore
the shock sensor press @ button, then within 5
seconds press
@ +
C:])))
, the system will respond with 1 long chirp.
NOTE: The system will
only
change
the shock
sensor
setting for
one
arm cycle
and will be defaulted
back
to normal operation the
next
time the system is armed.
Disarming the Security System
To disarm the system
press
the
(lJ
button.
The
parking lights will flash 1 time,
indicating the system is
disarmed
and has unlocked the
doors
(if
equipped
and
connected)
.
NOTE:
The
system is
defaulted
with Silent Choice enabled,
which
requires a
second press of the
it button to activate an audible arming
response
from the
vehicle. If
your
system is
set
up for 2 step unlock, a third
press
of
:';f
will activate
the audible response.
Two Stage Door Unlock (Optional)
If this feature is
enabled
on
your
system, pressing the
fiJ
button one time will
unlock
only the
driver's
door. Press
(i!
again within 5
seconds
to
unlock
the
remaining doors.
Activating the Trunk Release Feature (Optional)
If this feature is
enabled
on
your
system, pressing and holding the
tJ
button for 3
seconds will
open
the
vehicle's
trunk or hatch.
*Throughout this manual, 'press' refers to pressing for less than 1 second; 'press and hold' refers to pressing for more
than 2 seconds.
2010 Audiovox Electronics Corporation. All rights reserved. 3