Owner's Manual

Using Your Remote Control
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the @button. The
parking lights will flash 2 times, indicating the system
is armed, has locked the
doors (if equipped and connected) and activated the starter disable feature. The
LED status indicator will blink steadily, once per second.
NOTE: The system
is defaulted with Silent Choice enabled, which requires a
second press of the
@button to activate an audible arming response from the
vehicle.
Bypassing The Shock Sensor
To arm the system and ignore the shock sensor press @ button, then within 5
seconds press
@ + e;J»)) , the system will respond with 1 long chirp.
NOTE: The system will only change the shock sensor setting for one arm cycle
and will
be defaulted back to normal operation the next time the system is armed.
Disarming the Security System
To disarm the system press the Gl button. The parking lights will flash 1 time,
indicating the system is disarmed and has unlocked the doors (if equipped and
connected).
NOTE: The system
is defaulted with Silent Choice enabled, which requires a
second press of the
fiJ button to activate an audible arming response from the
vehicle.
Two Stage Door Unlock (Optional)
If this feature is enabled on your system, pressing the fiJ button one time will
unlock only the driver's door. Press riJ again within 5 seconds to unlock the
remaining doors.
Valet Mode
To engage valet mode:
1. Turn the ignition key to the ON position.
2. Press and hold the emergency override button.
3. The LED will light solid indicating that the system is in valet mode.
When valet mode
is activated the status LED will light solid, and all security
functions will
be disabled.
*Throughout this manual, 'press' refers to pressing for less than 1second; 'press and hold' refers to pressing for more
than 2 seconds.
2009 Audiovox Electronics Corporation.
All rights reserved. 3