Owner's Manual
Table Of Contents
1
2
3
6 Pin Main Harness
VVHrTE
WHITE/RED
VVHrTE
PARKING
LIGHT OUTPUT
PARKING
LIGHT
INPUT
PARKING
LIGHT OUTPUT
Locate the parking light output wire at the vehicle's light switch.
Verification: This wire registers positive voltage when the parking lights
are turned
on.
Positive switching Parking Lights:
Connect the WHITE/RED wire to a 15 Amp max fused battery source.
Connect the WHITE wire to the parking light output wire.
Negative switching Parking Lights:
Connect the WHITE/RED wire to a good chassis ground.
Connect the WHITE wire to the parking light output wire.
4
BLACK
GROUND
Connect the BLACK wire to a solid chassis ground point using a ring terminal and
self tapping screw (not supplied). Scrape away paint from the grounding point to
ensure a good connection. The recommended grounding point
is
a metal surface
in
the driver's side kick panel area.
NOTE:
Do
not ground the BLACK wire with any other vehicle components.
5
BROWN
SIREN OUTPUT ( + )
Locate a suitable mounting location
in
the engine compartment for the siren, away
from moving parts.
With the bell of the siren aiming downwards, secure the siren
in
place using self
tapping screws, being careful not do drill into any hoses, wiring or components.
Connect the BLACK siren wire to a chassis ground using a ring terminal and self
tapping screw (not supplied).
Route the BROWN siren output wire from the control module through the firewall
and connect to the
RED
wire
on
the siren.
NOTE:
Be
sure
to
loom the siren wires, and seal the grommet.
2009 Audiovox Electronics Corporation. All rights reserved.
5