User guide

640 Icon LCD Keypad 19n
The System Master Code has access to all Access Control
doors and all Access Control features at all times. Only the
card’s serial number and the choice of arming method can
be changed. If any of the other options are manually
changed, the System Master Code will immediately revert
to its original programming.
How do I change the System Master Code?
1. Enter your [
ACCESS CODE]. The functionality icons will illuminate.
2. Press the [0] key.
3. Press the [] key. “
SECTION” will illuminate
4. Enter either numbers [0] and [1] (DGP-848) or [0], [0], [1]
(DGP-NE96). “
DATA” will illuminate.
5. Enter a [
NEW CODE]. If the user code is of variable length, press
the [] key after entering the user code. When you have
entered the maximum number of digits, your keypad will emit a
half beep when it switches to User Options.
If there are more than 4 areas in the system, the System
Master Code cannot be modified using the Icon keypad.
6. User Options: Press the [] or [
S] key. Your keypad will emit
a half beep when it switches to Area Assignment. Pre-existing
assignments will illuminate.
7. Area Assignment: Press the [] or [
S] key.
8. Access Level: Press the [] or [
S] key.
9. Schedule Assignment: Press the [] or [
S] key.
10. Access Control User Options: Press the [] or [
S] key.
11. Access Card’s serial number: Press the [] or [
S] key to
save all the changes and exit.
Press the []
key at any point to exit without saving. Navigate
through the procedure using the [
S] (forward) or [T] (back) keys.
DGP2640_EU00.fm Page 19 Friday, April 8, 2005 11:28 AM