User guide

14 User Guide
5.8.1 Timed Auto-Arming
You can set the time that an area will arm itself automatically. An Exit
Delay will beep for one minute prior to the area(s) arming.
Auto-arming must be enabled in the control panel’s System
Options.
5.8.2 No Movement Auto-Arming
If there is no activity in an area during a specified period of time, your
control panel can arm the system. It can then send an arming report
to the monitoring station. Speak to your installer about this feature.
5.9 Bypass Programming
Your installer can program certain zones with the Bypass option. This
will enable you to bypass certain zones when you arm the protected
area. When a zone is bypassed, it will be ignored the next time you
arm the system. For example, if you are renovating part of a
protected area, you can bypass some of its zones. The system will
keep the bypassed zone(s) in memory until the area is armed. Once
the area is disarmed, the system will unbypass the zones.
How do I set the Auto-arming Timer?
1. Enter your [
ACCESS CODE].
2. Press the [0] key.
3. Press the [] key.
4. Select an area. If you have access to more than one area, the
number(s) corresponding to the area(s) to which you have access
will scroll in sequence. Press the number key representing the
area you want to arm.
5. Enter the time that you want the area to arm. Refer to
Programming the Time on page 30 for details on time formats.
6. Press the [] key at any point to exit without saving.
DGP2640_EU00.fm Page 14 Friday, April 8, 2005 11:28 AM