Programming instructions

12
3/C Ignition 2 Output (14 AWG-) (PINK/WHITE)
30 Amp Fused Relay Battery Feed (12 AWG) (RED)
Note: The 3/C wire is the ground trigger to an external Ignition 2
output relay.
Connect the external relay PINK/WHITE output wire to the Ignition
2 wire in the vehicle.
Connect the external relay 30 amp fused RED wire to a constant +12 volt
battery source, usually found at the vehicle ignition switch
4/C HVAC1 Output (14 AWG -) (ORANGE)
30 Amp Fused Relay Battery Feed (12 AWG) (RED)
Note: The 4/C wire is the ground trigger to an external HVAC 1
output relay.
Connect the external relay PINK/WHITE output wire to the Ignition
2 wire in the vehicle.
Connect the external relay 30 amp fused RED wire to a constant +12 volt
battery source, usually found at the vehicle ignition switch
5/C HVAC 2 Output (14 AWG+) (ORANGE/WHITE)
1/C HVAC 2 Polarity Input (14 AWG) (BLUE)
Note: Use these wires if the vehicle requires connection to a
second heater/AC circuit for the vehicle to operate properly during
remote start.
Connect the 5/C HVAC 2
output wire to the second
heater/AC wire at the ignition
switch.
Connect the 1/C wire to a
main power wire at the
ignition switch, preferably to
a wire other than the 4/B
main power connection.
3. Car Start Harness (C)
14/A Armed Output (20 AWG -)(ORANGE) 500mA
This wire will show a ground when the security system is armed.
15/A External Sensor Input (20 AWG -) (BLACK)
This wire is a ground input for an external sensor. Connect this
wire to the negative output of the external sensor.
Connect 2/C to a main power wire at the ignition switch, preferably
to a wire other than the 4/B main power connection.
2/C Battery (#14 AWG) (RED)
To Third
Ignition /
Heater Wire
To Third
Ignition /
Heater Wire
12V+
ConstantTo PINK 7/B
or ORANGE
/WHITE 5/C
Third Ignition or Third
HVAC Connection
10/C
Active
Output
CA-640.p65 10/20/03, 7:48 PM12