Remote Vehicle Control System CA-630 TM Owner's Manual Car Start, Security and Convenience System IMPORTANT NOTE: The operation of the IV-F65 as described in this manual is applicable to most vehicles. However, due to the engine type and configuration of some vehicles (i.e. diesel engines), some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information. CA 630 owners rev 7-04.
Table of Contents Features and Benefits of the CODE ALARM CA-630 ............ 4 Note: Any feature or function noted with “optional” requires additional installation labor, components and installation cost. See your dealer for details. Using the Security features .....................................................
Features and Benefits of the Code Alarm CA-630 Two Easy-to-Use Weather-Resistant Remote Controls The remote controls included with the Code Alarm CA-630 utilize durable, moisture resistant cases and sealed rubber buttons for reliability and long life. Rolling code technology prevents the transmitter signals from being duplicated. The button functions are clearly labeled to make the CA-630 simple to operate.
Using the Security and Keyless Entry features UNLOCK Button Press to Disarm Security System and Unlock Doors LOCK Button Press Twice for TwoStage Door Unlock* Press to Arm Security System and Lock Doors Press and Hold to Open Trunk FIND/PANIC Button START Button Press for Car Finder Press and Hold for Remote Start / Stop Press and Hold for Panic Alarm Press to Activate Rear Defroster Arming the Security System To arm the system, exit the vehicle, close all doors, then press* the LOCK button.
Using the Security and Keyless Entry features (cont.) 5 Activating Trunk Release Feature (vehicle must have power trunk/hatch) Press and hold the UNLOCK button for 2 seconds to open the vehicle trunk or hatch. Using the Progressive Car Finder Feature Press the FIND/PANIC button on the remote control to locate your vehicle. The horn will emit five short chirps at low volume, increasing in volume each of three times the button is pressed.
Using Valet / Service Mode You can turn off all remote start and Security functions by engaging the Valet/Service Mode: • To engage Valet/Service mode, turn the ignition key to the ON position (last position before start) and press the LOCK and UNLOCK buttons on the remote control simultaneouly.
Using Your Remote Starter (cont’d) Entering the Vehicle While It is Running via Remote Start 1. Press the UNLOCK button on the remote control to unlock the vehicle’s door(s) and turn off the alarm system (if it is not already off). 2. Enter the vehicle. Do not press the brake pedal. 3. Insert the key into the ignition and turn to the ON position. 4. Press the brake pedal. The remote starter disengages and the vehicle will operate normally.
Automatic Convenience Options The CA-630 performs a variety of automatic functions to enhance security and comfort. Some of these features are programmable at the time of installation. Please see your installer for further details. Illuminated Entry When the alarm system is disarmed, the vehicle courtesy lights will turn on for 1 minute, or until the vehicle is started or the system is re-armed.
System Maintenance Changing the Remote Control Battery The 12-volt alkaline battery supplied in your remote transmitter should last approximately one year, depending on usage. When the battery begins to weaken, you will notice a decrease in range, or the distance from your vehicle that your remote transmitter will operate. Follow the instructions below to change the remote transmitter battery. Open Back of Remote Transmitter 1.
System Maintenance (cont.) Deleting Lost or Stolen Remote Controls from Your System If one of your remote controls is lost or stolen, follow these instructions IMMEDIATELY to remove the control code from your system. 1. 2. Have all remaining remote controls available. Enter the control programming mode by following steps 1 - 5 of Adding Remote Controls to Your System (page 8). 3a.
Emergency Disarm Procedure If your remote control is lost or fails to function, use this procedure to disarm the CA-630 and start your vehicle. 1. Use the keys to enter the vehicle. The alarm will sound once the door is opened. 2. Insert the key into the ignition and turn to the ON position. 3. Locate and press the emergency override button. The alarm will turn off and then you will be able to start your vehicle.
Code Systems, Inc. Limited Lifetime Warranty A Code Systems Inc. (“CODE”) vehicle comfort, convenience and security system sold to a retail consumer purchaser by an authorized dealer of CODE and installed by an authorized dealer of CODE is warranted by CODE to the original retail consumer purchaser to be free from defects in workmanship and materials for the lifetime of the vehicle in which the system was originally installed.
Code Systems, Inc. Theft Protection Guarantee The Theft Protection Program is designed to provide the retail purchaser of a security system provided by CODE-ALARM, INC. (“CODE”) an additional benefit, at no additional cost to the purchaser, should their vehicle be stolen while protected by a CODE-ALARM security system.
CA 630 owners rev 7-04.
