Owner`s manual

Using Your Remote Control
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the LOCK icon
button on the remote control. The system will sound twice and the parking lights
will flash twice, indicating the system is armed. The doors will also lock at this
time (if equipped and connected). The blue dash mounted status indicator light
will blink steadily, once per second. To arm the system silently, press and hold the
LOCK icon button for 2 seconds. The parking lights will flash 2 times indicating
the system is armed and has locked the doors (if equipped and connected). The
blue dash mounted status indicator will blink steadily, once per second.
Pre-arm Mode
If the system sounds and the parking lights flash only once, this indicates that the
vehicle’s interior light is on or an entrance is left open. Check to see that all doors
hood and trunk are closed properly. Once all entrances are secured (and the
interior light is off), this system will sound/flash again. The system is now fully armed (If the entrance is
not secured within 4 minutes, the system will arm and ignore the unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system press the UNLOCK icon button. The system will sound and the parking lights will
flash once, and the doors will unlock (if equipped and connected). To disarm the system silently, press
and hold the UNLOCK icon button for 2 seconds. The parking lights will flash, indicating the system is
disarmed and has unlocked the doors (if equipped and connected).
Disabling/Enabling Confirmation Chirps
1. Turn the ignition key ON then OFF.
2. Within 10 seconds push and release the valet/override button 3 times.
3. The system will sound 2 times to disable confirmation chirps or 1 time to enable confirmation
chirps.
. Attempted Intrusion Identification
This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If
an intrusion attempt occurred, the system will sound 4 times and the parking lights will flash 3 times
when disarming the system. Enter the vehicle an observe the blue dash mounted status indicator light
to Identify which zone was triggered.
1. IT-s Interior Theft Sensor- 1 flash, pause 1 flash, etc.
2. Hood or Trunk Pin switch- 2 flashes, pause 2 flashes, etc.
3. Door Entry- 3 flashes, pause 3 flashes, etc.
The intrusion warning indicators are stored in the system’s memory and will be erased when the ignition
key is turned on.
*Throughout this manual, ‘press’ refers to pressing for less than 1 second.
3