User`s manual
Table Of Contents
- 535 User's Manual
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Basic Interface
- Chapter 3: Installation
- Chapter 4: Hardware Set Up
- Chapter 5: Software Configuration
- Chapter 6: Tuning
- Chapter 7: Applications
- Control Type
- Alarms
- Duplex Control
- Slidewire Position Proportioning Control
- Velocity Position Proportioning Control
- Staged Outputs
- Retransmission
- Digital Inputs
- Remote Setpoint
- Multiple Setpoints
- Multiple Sets of PID Values
- POWERBACK
- Self Tune–POWERTUNE®
- Ramp-To-Setpoint
- Input Linearization
- Load Line
- Security
- Reset Inhibition
- Process Variable Reading Correction
- Serial Communications
- Cascade Control
- Ratio Control
- Appendix 1: Menu Flowcharts
- Appendix 2: Parts List
- Appendix 3: Troubleshooting
- Appendix 4: Calibration
- Appendix 5: Specifications
- Appendix 6: Glossary
- Appendix 7: Isolation Block Diagram
- Return Procedures and Warranty Information
- 500 Series Process Controllers User's Manual
Introduction
2 Chapter 1 535 User’s Manual
535 MODES
There are three operating modes for the 535 controller:
OPERATION, the default mode of the controller. When the 535 is operating,
you can change setpoints, select manual control and change output level, ac-
knowledge alarms and monitor conditions.
SET UP, also referred to as configuration. Here you set up the basic functions
of the instrument such as input and output assignments, alarm types and spe-
cial functions.
TUNING, where you configure control function parameters for Proportional,
Integral and Derivation (PID). Use periodically to optimize the control perfor-
mance of the instrument.
ORDER CODE, PACKAGING INFORMATION
Compare the product number to the ordering code on page 3 to determine the
outputs and options installed on the 535. The product number is printed on the
label on the top of the controller case.
Included with this 535 are:
• a 535 User’s Manual
• mounting hardware
• 1 sheet of Engineering unit adhesive labels
WHERE TO GO NEXT
• To become more familiar with the 535 interface, continue to Chapter 2.
• For important hardware installation guidelines, see Chapters 3 and 4.
• For a detailed description of all the software menus and parameters of the
535, follow through Chapters 5 and 6. Appendix 1 can be used as a basic
guideline to these parameters.
TEXT FORMATTING IN THIS MANUAL
Feature Format
KEYS SET PT DISPLAY
or
ICONS OUT, ALM
MENUS CONFIG., TUNING,
PARAMETERS CYCLE TM:1, MIN.OUT2
PARAMETER VALUES OFF, SETPOINT, LAST OUT.
DISPLAY MESSAGES TOO HOT, OUT%,
SET PT DISPLAY