User`s manual
Table Of Contents
- 535 User's Manual
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Basic Interface
- Chapter 3: Installation
- Chapter 4: Hardware Set Up
- Chapter 5: Software Configuration
- Chapter 6: Tuning
- Chapter 7: Applications
- Control Type
- Alarms
- Duplex Control
- Slidewire Position Proportioning Control
- Velocity Position Proportioning Control
- Staged Outputs
- Retransmission
- Digital Inputs
- Remote Setpoint
- Multiple Setpoints
- Multiple Sets of PID Values
- POWERBACK
- Self Tune–POWERTUNE®
- Ramp-To-Setpoint
- Input Linearization
- Load Line
- Security
- Reset Inhibition
- Process Variable Reading Correction
- Serial Communications
- Cascade Control
- Ratio Control
- Appendix 1: Menu Flowcharts
- Appendix 2: Parts List
- Appendix 3: Troubleshooting
- Appendix 4: Calibration
- Appendix 5: Specifications
- Appendix 6: Glossary
- Appendix 7: Isolation Block Diagram
- Return Procedures and Warranty Information
- 500 Series Process Controllers User's Manual
60 Chapter 5 535 User's Manual
Controller Set Up
REM. SETPT.
Parameter Description Values
1 TYPE V/mA Input signal to be used for remote setpoint
2 RSP: LO RNG. Eng. unit value for low remote setpoint input value
3 RSP: HI RNG. Eng. unit value for high remote setpoint input value
4 RSP: LOW Lowest accepted setpoint value from remote setpoint
source
5 RSP: HIGH Highest accepted setpoint value from remote setpoint
source
6 TRACKING Whether the local setpoint will track the remote setpoint
7 BIAS LOW Lowest bias value that may be entered
8 BIAS HIGH Highest bias value that may be entered
9 RSP FIXED Status upon restoration of lost remote setpoint
RETRANS.
Parameter Description Values
1 TYPE:2 What is to be retransmitted for retransmission output 2
2 LOW RANGE:2 Low end of range in eng. units for retransmission output 2
3 HI RANGE:2 High end of range in eng. units for retransmission output 2
4 TYPE:3 What is to be retransmitted for retransmission output 3
5 LOW RANGE:3 Low end of range in eng. units for retransmission output 3
6 HI RANGE:3 High end of range in engl units for retransmission output 3
7 TYPE:4 What is to be retransmitted for retransmission output 4
8 LOW RANGE:4 Low end of range in eng. units for retransmission output 4
9 HI RANGE:4 High end of range in eng. units for retransmission output 4