User`s manual
Table Of Contents
- 535 User's Manual
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Basic Interface
- Chapter 3: Installation
- Chapter 4: Hardware Set Up
- Chapter 5: Software Configuration
- Chapter 6: Tuning
- Chapter 7: Applications
- Control Type
- Alarms
- Duplex Control
- Slidewire Position Proportioning Control
- Velocity Position Proportioning Control
- Staged Outputs
- Retransmission
- Digital Inputs
- Remote Setpoint
- Multiple Setpoints
- Multiple Sets of PID Values
- POWERBACK
- Self Tune–POWERTUNE®
- Ramp-To-Setpoint
- Input Linearization
- Load Line
- Security
- Reset Inhibition
- Process Variable Reading Correction
- Serial Communications
- Cascade Control
- Ratio Control
- Appendix 1: Menu Flowcharts
- Appendix 2: Parts List
- Appendix 3: Troubleshooting
- Appendix 4: Calibration
- Appendix 5: Specifications
- Appendix 6: Glossary
- Appendix 7: Isolation Block Diagram
- Return Procedures and Warranty Information
- 500 Series Process Controllers User's Manual
58 Chapter 5 535 User's Manual
Controller Set Up
CONTROL
Parameter Description Value
1 ALGORITHM Control algorithm used
2 D. SOURCE Variable used to determine the derivative value
3 ACTION:1 Action of the first control output
4 PV BREAK Output level if the process variable input is lost
5 LOW OUT. Lowest output value that can be achieved in automatic control
6 HIGH OUT. Highest output value that can be achieved in automatic control
7 ACTION:2 Action of the second control output
8 P.P. TYPE Type of position proportioning algorithm
9 CCW TIME Time it takes a motor to fully stroke in the CCW direction
10 CW TIME Time it takes a motor to fully stroke in the CW direction
11 MIN. TIME Minimum time for the motor to be on before taking action
12 S/W RANGE Full range resistance of the slidewire
13 OPEN F/B Feedback ohm value when the valve is open
14 CLOSE F/B Feedback ohm value when the valve is closed
15 OUT1 STOP Stopping point for control output 1 when staging outputs
16 OUT2 STRT Starting point for control output 2 when staging outputs