User`s manual
Table Of Contents
- 535 User's Manual
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Basic Interface
- Chapter 3: Installation
- Chapter 4: Hardware Set Up
- Chapter 5: Software Configuration
- Chapter 6: Tuning
- Chapter 7: Applications
- Control Type
- Alarms
- Duplex Control
- Slidewire Position Proportioning Control
- Velocity Position Proportioning Control
- Staged Outputs
- Retransmission
- Digital Inputs
- Remote Setpoint
- Multiple Setpoints
- Multiple Sets of PID Values
- POWERBACK
- Self Tune–POWERTUNE®
- Ramp-To-Setpoint
- Input Linearization
- Load Line
- Security
- Reset Inhibition
- Process Variable Reading Correction
- Serial Communications
- Cascade Control
- Ratio Control
- Appendix 1: Menu Flowcharts
- Appendix 2: Parts List
- Appendix 3: Troubleshooting
- Appendix 4: Calibration
- Appendix 5: Specifications
- Appendix 6: Glossary
- Appendix 7: Isolation Block Diagram
- Return Procedures and Warranty Information
- 500 Series Process Controllers User's Manual
56 Chapter 5 535 User's Manual
Controller Set Up
ALARMS
Parameter Description Value
1 ALM. TYPE:1 Type of alarm for alarm 1
2 ALM. SRC.:1 Source of value monitored by HIGH, LOW or HIGH/LOW
alarm 1
3 ALARM SP:1 Alarm setpoint for alarm 1 (except for HIGH/LOW)
4A HIGH SP:1 High alarm setpoint for HIGH/LOW alarm 1
4A LOW SP:1 Low alarm setpoint for HIGH/LOW alarm 1
5 DEADBAND:1 Deadband for alarm 1
6 ALM.:1 OUT. Output number for alarm 1
7 LATCHING:1 Latching sequence for alarm 1
8 ACK.:1 Whether alarm 1 may be acknowledged
9 POWER UP:1 How alarm 1 will be treated upon power up
10 MESSAGE:1 Nine character message associated with alarm 1
11 ALM. TYPE:2 Type of alarm for alarm 2
12 ALM. SRC.:2 Source of value monitored by HIGH, LOW or HIGH/LOW
alarm 2
13 ALARM SP:2 Alarm setpoint for alarm 2 (except for HIGH/LOW)
14A HIGH SP:2 High alarm setpoint for HIGH/LOW alarm 2
14B LOW SP:2 Low alarm setpoint for HIGH/LOW alarm 2
15 DEADBAND :2 Deadband for alarm 2
16 ALM.:2 OUT. Output number for alarm 2
17 LATCHING :2 Latching sequence for alarm 2
18 ACK.:2 Whether alarm 2 may be acknowledged
19 POWER UP:2 How alarm 2 will be treated upon power up
20 MESSAGE:2 Nine character message associated with alarm 2
21 FAULT Alarm relay status if fault condition is detected
22 OUTPUT Output if the rate-of-change alarm is tripped
23 RATE TIME Time period over which a rate-of-change alarm is
determined