User`s manual
Table Of Contents
- 535 User's Manual
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Basic Interface
- Chapter 3: Installation
- Chapter 4: Hardware Set Up
- Chapter 5: Software Configuration
- Chapter 6: Tuning
- Chapter 7: Applications
- Control Type
- Alarms
- Duplex Control
- Slidewire Position Proportioning Control
- Velocity Position Proportioning Control
- Staged Outputs
- Retransmission
- Digital Inputs
- Remote Setpoint
- Multiple Setpoints
- Multiple Sets of PID Values
- POWERBACK
- Self Tune–POWERTUNE®
- Ramp-To-Setpoint
- Input Linearization
- Load Line
- Security
- Reset Inhibition
- Process Variable Reading Correction
- Serial Communications
- Cascade Control
- Ratio Control
- Appendix 1: Menu Flowcharts
- Appendix 2: Parts List
- Appendix 3: Troubleshooting
- Appendix 4: Calibration
- Appendix 5: Specifications
- Appendix 6: Glossary
- Appendix 7: Isolation Block Diagram
- Return Procedures and Warranty Information
- 500 Series Process Controllers User's Manual
535 User's Manual Chapter 5 55
Controller Set Up
PV1 INPUT
Parameter Description Value
1 PV1 TYPE PV1 sensor or range to be used
2 DEG. F/C/K PV1 temperature engineering unit
3 DECIMAL PV1 decimal point position
4 LINEARIZE Type of PV1 input linearization
5 LOW RANGE Engineering unit value for lowest PV1 input value
6 HI RANGE Engineering unit value for highest PV1 input value
7 SP LO LIM. Lowest setpoint value that can be entered
8 SP HI LIM. Highest setpoint value that can be entered
9 SP RAMP Rate of change for setpoint changes
10 FILTER Setting for the low pass PV1 input filter (in seconds)
11 OFFSET Offset to PV1 in engineering units
12 GAIN Gain to PV1
13 RESTORE Control mode when a broken PV1 is restored
PV2 INPUT
Parameter Description Value
1 PV2 SETUP
Makes PV2 input parameters match PV1, or user definable.
2 PV2 TYPE PV2 sensor or range to be used
3 DECIMAL PV2 decimal point position
4 LINEARIZE Type of PV2 input linearization
5 LOW RANGE Engineering unit value for lowest PV2 input value
6 HI RANGE Engineering unit value for highest PV2 input value
7 FILTER Setting for the low pass PV2 input filter (in seconds)
8 OFFSET Offset to the PV2 in engineering units
9 GAIN Gain to PV2
10 RESTORE Control mode when a broken PV2 is restored