User`s manual
Table Of Contents
- 535 User's Manual
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Basic Interface
- Chapter 3: Installation
- Chapter 4: Hardware Set Up
- Chapter 5: Software Configuration
- Chapter 6: Tuning
- Chapter 7: Applications
- Control Type
- Alarms
- Duplex Control
- Slidewire Position Proportioning Control
- Velocity Position Proportioning Control
- Staged Outputs
- Retransmission
- Digital Inputs
- Remote Setpoint
- Multiple Setpoints
- Multiple Sets of PID Values
- POWERBACK
- Self Tune–POWERTUNE®
- Ramp-To-Setpoint
- Input Linearization
- Load Line
- Security
- Reset Inhibition
- Process Variable Reading Correction
- Serial Communications
- Cascade Control
- Ratio Control
- Appendix 1: Menu Flowcharts
- Appendix 2: Parts List
- Appendix 3: Troubleshooting
- Appendix 4: Calibration
- Appendix 5: Specifications
- Appendix 6: Glossary
- Appendix 7: Isolation Block Diagram
- Return Procedures and Warranty Information
- 500 Series Process Controllers User's Manual

535 User's Manual Table of Contents v
Table of Contents
FIGURE DESCRIPTION PAGE
Figure 7.14 ..... Noise Band Values for Temperature Inputs ......................... 93
Figure 7.15 ..... Deadtime and Time Constant ............................................. 93
Figure 7.16 ..... Square Root Linearization Formula .................................... 95
Figure 7.17 ..... 15-point Linearization Curve ............................................... 96
Figure 7.18 ..... Load Line Example ............................................................ 97
Figure 7.19 ..... Heat Exchanger Control Loop for Steam Supply ................ 100
Figure 7.20 ..... Cascade Control of Product Temperature ......................... 101
Figure 7.21 ..... Ratio Control in Mixing Application .................................... 103
Figure A4.1 ..... 535 Rear Terminals for Calibration ........................................ 7
Figure A4.2 ..... Flowchart Calibration Menus ................................................ 7
Figure A4.3 ..... Jumper Locations on the Microcontroller Circuit Board ........... 8
Figure A4.4 ..... Input Calibration Wiring ........................................................ 8
Figure A4.5 ..... Thermocouple/Cold Junction Calibration Wiring .................... 9
Figure A4.6 ..... Analog mA Input Calibration Wiring ..................................... 10
Figure A4.7 ..... Analog mA Input Jumper Positions ..................................... 10
Figure A4.8 ..... Milliamp Output Calibration Wiring ...................................... 11
Figure A4.9 ..... Output Module Menu Cycle ................................................ 11
Figure A4.10 ... Slidewire Test Wiring ......................................................... 12