User`s manual

iv Table of Contents 535 User's Manual
Table of Contents
List of Figures
FIGURE DESCRIPTION PAGE
Figure 2.1 ....... Operator Interface ............................................................... 5
Figure 2.2 ....... Before and After Acknowledging an Alarm ............................ 8
Figure 3.1 ....... Instrument Panel & Cutout Dimensions ............................... 11
Figure 3.2 ....... Attaching mounting collar ................................................... 11
Figure 3.3 ....... All 535 Terminal Assignments ............................................ 12
Figure 3.4 ....... AC Power Input Terminals ................................................. 13
Figure 3.5 ....... Process Variable Terminals ............................................... 13
Figure 3.6 ....... PV1 and PV2 Wiring for Milliamp, RTD and Voltage Inputs ... 14
Figure 3.7 ....... PV1 and PV2 Wiring for Milliamp Inputs with Internal and
External Power Supply ...................................................... 15
Figure 3.8 ....... Digital input Wiring with a Switch or Relay ............................ 16
Figure 3.9 ....... Digital Input Wiring with an Open Collector .......................... 16
Figure 3.10 ..... Remote Setpoint Terminals ................................................ 16
Figure 3.11 ..... Mechanical Relay Output Wiring ......................................... 17
Figure 3.12 ..... SSR Relay Output Wiring ................................................... 17
Figure 3.13 ..... DC Logic Output Wiring ..................................................... 18
Figure 3.14 ..... Milliamp Output Wiring ....................................................... 18
Figure 3.15 ..... Position Proportioning Output Wiring .................................. 18
Figure 3.16 ..... Serial Communications Terminals ...................................... 19
Figure 3.17 ..... 535 Wiring with Limit Control .............................................. 20
Figure 4.1 ....... Location of Printed Circuit Boards for Hardware
Configuration .................................................................... 21
Figure 4.2 ....... The Microcontroller Circuit Board, the Option Board, and the
Power Supply Board .......................................................... 22
Figure 4.3 ....... Representation of Module .................................................. 25
Figure 4.4 ....... Install Communications Module onto
Microcontroller Board ........................................................ 26
Figure 5.1 ....... Menu Flowchart for Set Up ................................................. 27
Figure 5.2 ....... Independent vs. Dependent Parameters ............................. 28
Figure 5.3 ....... Configuration Flowchart ..................................................... 28
Figure 6.1 ....... Access the Tuning Menu Block .......................................... 63
Figure 7.1 ....... Alarm Examples ................................................................ 75
Figure 7.2 ....... Duplex with reverse and direct acting outputs ...................... 77
Figure 7.3 ....... Duplex with direct and reverse acting outputs ...................... 77
Figure 7.4 ....... Duplex with two reverse acting outputs ............................... 78
Figure 7.5 ....... Duplex with a gap between outputs ..................................... 78
Figure 7.6 ....... Duplex with overlapping outputs and output limits ................ 79
Figure 7.7 ....... Duplex with various relative gain settings ............................ 79
Figure 7.8 ....... Duplex with one ON/OFF output ......................................... 80
Figure 7.9 ....... Duplex with two ON/OFF outputs ....................................... 80
Figure 7.10 ..... Staged Outputs Example ................................................... 83
Figure 7.11 ..... Combinations of Closed Digital Inputs for Each Setpoint (based
on BCD logic) .................................................................... 84
Figure 7.12 ..... Pretune TYPE 1, 2 and 3 with Adaptive Tune ....................... 90
Figure 7.13 ..... Noise Band Calculation Example ........................................ 92