User`s manual
Table Of Contents
- 535 User's Manual
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Basic Interface
- Chapter 3: Installation
- Chapter 4: Hardware Set Up
- Chapter 5: Software Configuration
- Chapter 6: Tuning
- Chapter 7: Applications
- Control Type
- Alarms
- Duplex Control
- Slidewire Position Proportioning Control
- Velocity Position Proportioning Control
- Staged Outputs
- Retransmission
- Digital Inputs
- Remote Setpoint
- Multiple Setpoints
- Multiple Sets of PID Values
- POWERBACK
- Self Tune–POWERTUNE®
- Ramp-To-Setpoint
- Input Linearization
- Load Line
- Security
- Reset Inhibition
- Process Variable Reading Correction
- Serial Communications
- Cascade Control
- Ratio Control
- Appendix 1: Menu Flowcharts
- Appendix 2: Parts List
- Appendix 3: Troubleshooting
- Appendix 4: Calibration
- Appendix 5: Specifications
- Appendix 6: Glossary
- Appendix 7: Isolation Block Diagram
- Return Procedures and Warranty Information
- 500 Series Process Controllers User's Manual
Controller Set Up
Access Set Up Return to Operation Next menu Next parameter Next value Access Tuning Return to Operation
+
FAST MENU
DISPLAY
+
MENU MENU
▲ ▼
MENU DISPLAYFAST
32 Chapter 5 535 User's Manual
12. CONTACT 1
Defines the operation of the first digital input.
• SETPT. 1–8 Assigns the first four digital inputs to select
setpoints 1 through 8 via BCD signal
• REM. SETPT. Makes the remote setpoint active
D MANUAL Trips the controller to manual control
• 2ND. SETPT. Makes the second setpoint active
• 2ND. PID Makes the second set of PID values active
• ALARM ACK. Acknowledges alarms
• RST. INHBT. Deactivates the reset term
• D.A./R.A. Switches the control action
• STOP A/T Suspends the adaptive tune function
• LOCK. MAN. Locks controller in manual control
• UP KEY Remote
▲▲
▲▲
▲ function
• DOWN KEY Remote
▼ ▼
▼ ▼
▼ function
• DISP KEY Toggle between SP DEV or OUT%
• FAST KEY Activates FAST key
• MENU KEY Activates MENU key.
• COMM. ONLY Status readable only through communications
• PV2.SWITCH Switches between PV1 and PV2
13. CONTACT 2
Defines the operation of the second digital input.
D REM. SETPT. Makes the remote setpoint active
• MANUAL Trips the controller to manual control
• 2ND. SETPT. Makes the second setpoint active
• 2ND. PID Makes the second set of PID values active
• ALARM ACK. Acknowledges alarms
• RST. INHBT. Deactivates the reset term
• D.A./R.A. Switches the control action
• STOP A/T Suspends the adaptive tune function
• LOCK. MAN. Locks controller in manual control
• UP KEY Remote
▲▲
▲▲
▲ function
• DOWN KEY Remote
▼ ▼
▼ ▼
▼ function
• DISP KEY Toggle between SP DEV or OUT%
• FAST KEY Activates FAST key
• MENU KEY Activates MENU key.
• COMM. ONLY Status readable only through communications
• PV2.SWITCH Switches between PV1 and PV2
CONTACT 2
REM.SETPT.
CONTACT 1
MANUAL