User`s manual
Table Of Contents
- 535 User's Manual
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Basic Interface
- Chapter 3: Installation
- Chapter 4: Hardware Set Up
- Chapter 5: Software Configuration
- Chapter 6: Tuning
- Chapter 7: Applications
- Control Type
- Alarms
- Duplex Control
- Slidewire Position Proportioning Control
- Velocity Position Proportioning Control
- Staged Outputs
- Retransmission
- Digital Inputs
- Remote Setpoint
- Multiple Setpoints
- Multiple Sets of PID Values
- POWERBACK
- Self Tune–POWERTUNE®
- Ramp-To-Setpoint
- Input Linearization
- Load Line
- Security
- Reset Inhibition
- Process Variable Reading Correction
- Serial Communications
- Cascade Control
- Ratio Control
- Appendix 1: Menu Flowcharts
- Appendix 2: Parts List
- Appendix 3: Troubleshooting
- Appendix 4: Calibration
- Appendix 5: Specifications
- Appendix 6: Glossary
- Appendix 7: Isolation Block Diagram
- Return Procedures and Warranty Information
- 500 Series Process Controllers User's Manual
535 User's Manual Chapter 5 29
Controller Set Up
CONFIGURATION AND OPERATION
Figure 5.3 shows the relationships among the different modes of the 535 and
the configuration menus:
• SET UP menus can only be accessed from manual control. To transfer the
535 from automatic to manual control, press MANUAL.
• To access the SET UP menus, hold down FAST and press MENU. The
MENU key will illuminate; and CONFIG will appear in the 2nd display.
• To access the parameters for a particular menu, press MENU.
• To select a parameter value, use
▲▲
▲▲
▲ and
▼▼
▼▼
▼. Press MENU to advance to the
next parameter, or FAST+MENU to advance to the next menu.
• To advance to the next menu, press FAST+MENU.
• TUNING mode (and the TUNING menu) can be accessed from either au-
tomatic or manual control. To access the tuning menu, press MENU .
• To return controller to manual control, press DISPLAY or SET PT.
A key to these functions (as shown below) appears at the bottom of every page
in the menu section of this chapter.
WHERE TO GO NEXT
• For information about all the software menus and parameters, continue read-
ing this chapter. Refer to Appendix D for a quick-reference flowchart of all
menus and parameters.
• For information about the installed options on the 535, compare the product
label on top of the controller to the order code in Chapter 1.
• To mount the controller and configure the wiring of the 535 for inputs and
outputs, see Chapter 3.
• To alter the output module and jumper configuration of the controller, see
Chapter 4.
• For more information about applications for the 535, see Chapter 6.
• For more information about the Tuning function of the 535, see Chapter 7.
Access Set Up Return to Operation Next menu Next parameter Next value Access Tuning Return to Operation
+
FAST MENU
DISPLAY
+
MENU MENU
▲ ▼
MENU
DISPLAYFAST