User`s manual
Table Of Contents
- 535 User's Manual
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Basic Interface
- Chapter 3: Installation
- Chapter 4: Hardware Set Up
- Chapter 5: Software Configuration
- Chapter 6: Tuning
- Chapter 7: Applications
- Control Type
- Alarms
- Duplex Control
- Slidewire Position Proportioning Control
- Velocity Position Proportioning Control
- Staged Outputs
- Retransmission
- Digital Inputs
- Remote Setpoint
- Multiple Setpoints
- Multiple Sets of PID Values
- POWERBACK
- Self Tune–POWERTUNE®
- Ramp-To-Setpoint
- Input Linearization
- Load Line
- Security
- Reset Inhibition
- Process Variable Reading Correction
- Serial Communications
- Cascade Control
- Ratio Control
- Appendix 1: Menu Flowcharts
- Appendix 2: Parts List
- Appendix 3: Troubleshooting
- Appendix 4: Calibration
- Appendix 5: Specifications
- Appendix 6: Glossary
- Appendix 7: Isolation Block Diagram
- Return Procedures and Warranty Information
- 500 Series Process Controllers User's Manual

ii Table of Contents 535 User's Manual
Table of Contents
CHAPTER 5
CONTROLLER SET UP (cont’d)
Text Formatting in This Manual.......................................................... 29
Software Menus and Parameters ...................................................... 30
CONFIG.................................................................................. 30
PV1 INPUT ............................................................................. 34
PV2 INPUT ............................................................................. 36
CUST. LINR. ........................................................................... 38
CONTROL .............................................................................. 39
ALARMS ................................................................................. 41
REM. SETPT. .......................................................................... 46
RETRANS............................................................................... 47
SELF TUNE ............................................................................ 48
SPECIAL ................................................................................ 50
SECURITY.............................................................................. 51
SER. COMM. .......................................................................... 52
Parameter Value Charts ................................................................... 50
CHAPTER 6
TUNING .......................................................................................... 63
Overview ......................................................................................... 63
TUNING Menu Parameters ............................................................... 64
TUNING Parameter Value Chart ....................................................... 68
Self Tune Messages and Troubleshooting ......................................... 70
CHAPTER 7
APPLICATIONS .............................................................................. 71
A. Control Type ................................................................................ 71
B. Alarms ......................................................................................... 72
C. Duplex Control ............................................................................. 76
Duplex with reverse and direct acting outputs ............................ 77
Duplex with direct and reverse acting outputs ............................ 77
Duplex with 2 reverse acting outputs ......................................... 78
Duplex with a gap between outputs ........................................... 78
Duplex with overlapping outputs and output limits ...................... 79
Duplex with various relative gain settings ................................... 79
Duplex with one ON/OFF output ............................................... 80
Duplex with two ON/OFF outputs .............................................. 80
D. Slidewire Position Proportioning Control ........................................ 81
E. Velocity Position Proportioning Control .......................................... 82
F. Staged Outputs ............................................................................ 83
G. Retransmission ............................................................................ 83
H. Digital Inputs ................................................................................ 84
I. Remote Setpoint .......................................................................... 86
J. Multiple Setpoints ......................................................................... 87
K. Multiple Sets of PID Values ........................................................... 87
L. Powerback .................................................................................. 88
M. Self Tune—Powers POWERTUNE® ............................................ 89
Pretune by Itself ....................................................................... 89
Pretune TYPE 1 and Adaptive Tune .......................................... 91
Pretune TYPE 2 or TYPE 3 and Adaptvie Tune .......................... 91
Adaptive Tune by Itself ............................................................. 92
Self Tune with Multiple Sets of PID ............................................ 94
Self Tune with Time Proportioning Outputs ................................ 94
PAGE