User`s manual
Table Of Contents
- 535 User's Manual
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Basic Interface
- Chapter 3: Installation
- Chapter 4: Hardware Set Up
- Chapter 5: Software Configuration
- Chapter 6: Tuning
- Chapter 7: Applications
- Control Type
- Alarms
- Duplex Control
- Slidewire Position Proportioning Control
- Velocity Position Proportioning Control
- Staged Outputs
- Retransmission
- Digital Inputs
- Remote Setpoint
- Multiple Setpoints
- Multiple Sets of PID Values
- POWERBACK
- Self Tune–POWERTUNE®
- Ramp-To-Setpoint
- Input Linearization
- Load Line
- Security
- Reset Inhibition
- Process Variable Reading Correction
- Serial Communications
- Cascade Control
- Ratio Control
- Appendix 1: Menu Flowcharts
- Appendix 2: Parts List
- Appendix 3: Troubleshooting
- Appendix 4: Calibration
- Appendix 5: Specifications
- Appendix 6: Glossary
- Appendix 7: Isolation Block Diagram
- Return Procedures and Warranty Information
- 500 Series Process Controllers User's Manual
Install / Wire
18 Chapter 3 535 User's Manual
POSITION
PROPORTIONING
OUTPUT
11
12
3
10
Slidewire Wiper
0–1050 Ohm
CW
CCW
Electric Motor Actuator
CW
Winding
6
5
4
COM
CW
CCW
COM
Actuator
Supply
Current
CCW
Winding
3. DC Logic (SSR Drive) Output
• Output 1 is always Control 1.
• Respective jumper J1, J2 or J3 must be set to normally open for DC
Logic output.
• Output 4 is always configured for normally open.
4. Milliamp Output
• Output 1 is always Control 1.
• Respective jumper J1, J2 or J3 must be set to normally open for
Milliamp output.
5. Position Proportioning Output
(with or without Slidewire Feedback)
3
4
_
+
Load
_
+
Terminals used
with Output
Module 2
Terminals used
with Output
Module 3
Terminals used
with Output
Module 4
7
8
5
6
Terminals used
with Output
Module 1
15
16
3
4
3
4
_
+
Load
Terminals used
with Output
Module 2
Terminals used
with Output
Module 3
Terminals used
with Output
Module 4
7
8
5
6
Terminals used
with Output
Module 1
15
16
3
4
Figure 3.13
DC Logic Output Wiring
Figure 3.15
Position Proportioning Output
Wiring
Figure 3.14
Milliamp Output Wiring