User`s manual

Install / Wire
535 User's Manual Chapter 3 11
CHAPTER 3
INSTALLATION
MOUNTING THE CONTROLLER
The 535 front face is NEMA 4X rated (waterproof). To obtain a waterproof seal
between the controller and the panel, follow these directions:
1. The 535 fits in a standard 1/4 DIN cutout. Mount the 535 in any panel with
a thickness from .06 in. to .275 in. (1.5 mm to 7.0 mm).
2. Figure 3.1 shows the controller and panel dimensions. The panel cutout
must be precise, and the edges free from burrs and waves.
3. Place bezel gasket around the controller case (starting at the back of con-
troller). Then, slide the gasket against the back of the bezel.
4. With the bezel gasket in place, insert the 535 into the panel cutout from the
front of the panel.
5. Slide the mounting collar over the back of the case, as shown in Figure 3.2.
The collar clip edges will lock with matching edges on the controller case.
Figure 3.1
Instrument Panel & Cutout
Dimensions
3.770 (95.76)
3.770 (95.76)
1.180 (29.97)
6.000 (152.40)
7.180 (182.37) OVERALL LENGTH
3.585 (91.06)
PANEL
SIDE
3.622 (92.00) MIN.
3.653 (92.80) MAX.
3.622 (92.00) MIN. 3.653 (92.80) MAX.
CUTOUT
FRONT
BEZEL
GASKET
535
MANUAL DISPLAY SET PT
s
t
ACK MENU FAST
OUT
1 2
ALM
1 2
Mounting Clip
Collar Screws (1 of 4)
Mounting Collar
Front Panel
Figure 3.2
Attaching mounting collar