User`s manual
Table Of Contents
- 535 User's Manual
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Basic Interface
- Chapter 3: Installation
- Chapter 4: Hardware Set Up
- Chapter 5: Software Configuration
- Chapter 6: Tuning
- Chapter 7: Applications
- Control Type
- Alarms
- Duplex Control
- Slidewire Position Proportioning Control
- Velocity Position Proportioning Control
- Staged Outputs
- Retransmission
- Digital Inputs
- Remote Setpoint
- Multiple Setpoints
- Multiple Sets of PID Values
- POWERBACK
- Self Tune–POWERTUNE®
- Ramp-To-Setpoint
- Input Linearization
- Load Line
- Security
- Reset Inhibition
- Process Variable Reading Correction
- Serial Communications
- Cascade Control
- Ratio Control
- Appendix 1: Menu Flowcharts
- Appendix 2: Parts List
- Appendix 3: Troubleshooting
- Appendix 4: Calibration
- Appendix 5: Specifications
- Appendix 6: Glossary
- Appendix 7: Isolation Block Diagram
- Return Procedures and Warranty Information
- 500 Series Process Controllers User's Manual
535 User's Manual Appendix 1 A-1
Menu Flowcharts
APPENDIX 1
MENU FLOWCHARTS
SEC. CODE SP ADJUST AUTO./MAN. SP SELECT ALARM ACK. TUNING
SET UP
CONFIG.
PV1 INPUT
CUST. LINR.
CONTROL
ALARMS
REM. SET PT.
RETRANS.
SELF TUNE
SPECIAL
SECURITY
SER. COMM.
CTRL. TYPE LINE FREQ.
PV1 TYPE DEG. F/C/K DECIMAL LINEARIZE LOW RANGE
HI RANGE
RESTORE
SP LO LIM. SP HI LIM. SP RAMP FILTER OFFSET
GAIN
PV2 INPUT
PV2 SETUP DECIMAL LINEARIZE LOW RANGE
HI RANGE
RESTORE
FILTER OFFSET
GAIN
1ST. INPUT 1ST. PV XTH. INPUT XTH. PV 15TH. INPUT* 15TH. PV*
ALM. TYPE:1 ALM.SRC.:1 ALARM SP:1 HIGH SP:1 LOW SP:1 DEADBAND:1
ALM.:1 OUT. LATCHING:1 ACK.:1
POWER UP:1
MESSAGE:1
TYPE:2 LOW RANGE:2 HI RANGE:2 TYPE:X LOW RANGE:3 HI RANGE:3
TYPE:4 LOW RANGE:4 HI RANGE:4
AUTO. TRIP TRIP DEV. DES. OUTPT. POWER UP PWR. UP:OUT. PWR. UP:SP
NO. OF SP
CONFIGURE
BAUD RATE CRC SHED TIME SHED MODE
SHED OUT.
ANLG. RNG.:1ANLG. RNG.:2 ANLG. RNG.:3
CONTACT 1
CONTACT 4 CONTACT 5
CONTACT 3 LOOP NAME
DEADBAND:2LATCHING:2LOW SP:2HIGH SP:2ALM.SRC.:2
ALM. TYPE:2
ALARM SP:2
ALM.:2 OUT.
OUTPUT
LATCHING:2
RATE TIME
ACK.:2 POWER UP:2 MESSAGE:2 FAULT
RSP:LO RNG.
RSP:HI RNG.
RSP:LOW
TRACKING
BIAS LOW RSP FIXEDBIAS HIGH
TYPE V/MA
RSP:HIGH
DESIG. SPSHED SP
STATION
TYPE
OUT. STEP
LOW LIMIT
PRETUNE
TUNE PT. HI LIMIT
TIMEOUT
MODE
DEAD TIMERESP. TIME
NOISE BND.
ALGORITHM D. SOURCE
ACTION:2 P.P. TYPE
ACTION: 1 PV BREAK LOW OUT.
CCW TIME
HIGH OUT.
CW TIME MIN. TIME
S/W RANGE
OUT2STRT.
OPEN F/B
OUT1STOPCLOSE F/B
CONTACT 2
OUTPUT 4
OUTPUT 3OUTPUT 2PV SOURCE REM. SETPT.
ANLG.RNG.: 4
PV2 TYPE