Installation guide

3 GREEN/WHITE
PULSE AFTER SHUTDOWN ( - )
This wire will supply a
(-) 200mA pulse after the remote start shuts down. This
is typically used to re-lock the vehicle's doors
if they unlock upon remote start
shutdown.
It can also be used to pulse a door pin-switch wire to prevent the vehicle's
accessories from remaining on after remote start shutdown.
This output is configurable in option programming.
4
BLACK/YELLOW
PULSE DURING
CRANK (-)
Locate the vehicle's second starter (crank) wire at the ignition switch. (if equipped)
Verification: This wire registers voltage only in the start (crank) position of
the ignition switch.
This wire will supply a ( - ) 200mA output and can be configured
in option
programming.
2 Pin Lock Output Harness
1
BLUE
UNLOCK
(-)
The door unlock output wire provides an output only while the remote start feature is
active.
2014 Voxx Electronics Corporation. All rights reserved.
9