Installation guide

6
4
BROWN/RED
BRAKE
INPUT
(
+ )
Locate the
vehicle's
brake
light
wire at the brake pedal
mounted switch. This
connection is required for Remote Start.
Verification:
This wire registers positive
voltage
when the brake pedal
is
pressed.
Connect the
BROWN/RED
wire to the
vehicle's
brake
light
wire.
3 Pin Parking Light Harness
1
BLACK
GROUND
Connect the
BLACK
wire to a
solid
chassis ground point using a ring
terminal
and
self
tapping screw (not
supplied). Scrape away paint from the grounding point to
ensure a good connection.
The
recommended grounding point is a
metal
surface in
the driver's side kick panel area.
NOTE:
Do not ground the
BLACK
wire with any other
vehicle components.
2
WHITE/RED
PARKING LIGHT
INPUT
3
WHITE
PARKING LIGHT
OUTPUT
Locate the parking
light
output wire at the
vehicle's light
switch.
Verification:
This wire registers positive
voltage
when the parking
lights
are
turned on.
Positive switching Parking Lights:
Connect the
WHITE/RED
wire to a 15
Amp
max
fused battery source.
Connect the
WHITE
wire to the parking
light
output wire.
Negative switching Parking Lights:
Connect the
WHITE/RED
wire to a good chassis ground.
Connect the
WHITE
wire to the parking
light
output wire.
ca4054-
4554
Install
rev A