Installation guide

16
Feature Bank 4 - Remote Start
Control
1 - Not
Available.
2 - Run Time: Controls
the time
in
minutes that the
vehicle will
stay running under
control
of
the remote start until
the system times out. The system may also
be shut
down at any time by use
of
the transmitter or system shutdowns.
3-
Running Lights:
Controls
the
WHITE
parking
light output wire during remote
start.
Steady - Parking lights
constant during the remote start cycle.
Flashing
- Parking
lights flash
at a slow
pace during the remote start
cycle.
4
- Tach Mode: Determines how the system monitors the engine running during
remote start.
Tach
- Hard wired
directly
to the tach wire
of
the
vehicle
to monitor
AC
voltage.
Tach
less
(Crank Average/Voltage) - Determines crank time by averaging
the
last
8 times the
vehicle
was started with the key and then monitors the
change
in
voltage after remote start.
Hybrid (Crank Average
I
No
Voltage)
- Determines crank time by averaging
the
last
8 times the vehicle
was started with the
key.
DBI
Port - Monitors the
vehicle's
tach rate through
an
interface
module
connected to the
DBI
port.
5-
Voltage Level:
The
voltage
variance for remote start when set to tachless.
(see
tach mode)
HIGH-
The variance
in
battery
voltage
from before the remote start
is
activated to after the engine
is
running must be greater than
0.5 volts.
LOW
- The variance
in
battery
voltage
from before the remote start
is
activated to after the engine is running may be
less
than
0.5 volts.
6
- Crank Time: Preset output times for the PURPLE starter wire.
1 Second
0.8
Seconds 1.5 Seconds
2 Seconds 4 Seconds
ca4054-
4554
Install
rev A