Installation guide

Tach Programming
The unit
will not operate
unless
tach is programmed or tach less
option is
turned
ON.
If
an
attempt
is
made
to
start the
vehicle
via the remote start without first
programming tach, the unit
will flash
the parking
lights
7 times indicating tach has not
been learned and stored.
If
the tach rate is not properly
programmed to the specific
vehicle,
the unit may not
realize
that the
vehicle
is running
in
certain instances and
reengage the starter motor.
The Remote Start unit will learn the tach rate
of
most
vehicle's single coil, multiple coil
packs, or
single
injector.
To
learn
tach:
1.
Turn the ignition key to the ON position.
2.
Press and
release
the valet/override button 3 times.
3.
Immediately turn the ignition key
OFF.
4.
Press and
hold the
valet/override
button, then start the
vehicle
using
the
key.
5.
When the unit senses the tach
signal,
the parking
lights will begin to
flash.
6.
Allow
the
vehicle
to
settle
to a normal idle
speed.
7.
Release
the
valet/program push-button switch. The parking lights will
stay
on
solid
indicating that the
learned
tach
signal
is stored and the
unit has exited tach
learn
mode.
NOTE:
If
the unit
fails
to
learn
tach rate due to
an
improper tach connection or a
poor tach source, the parking
lights will
not flash.
To
correct this situation,
locate
and
connect the
PURPLE/WHITE
wire
to
the proper tach
signal,
and then repeat the tach
learn
routine.
Smart Tachless Mode
Smart
Tach
less
Mode is
available only
if a tach
signal
has never been
learned
to the
system and when activated will automatically change the Tach Mode feature
in
option
programming to
Tach
less
without the need to enter the feature programming mode.
1.
Activate the remote start. The parking
lights should
begin
flashing 7
times indicating no tach signal
has been
learned.
2.
Within the 7
flash
time period, press and
hold the
0
button.
3.
One
extended parking
light flash
(1.5 seconds) will
indicate the
system is now
in
tachless mode.
14 ca4054 - 4554
Install
rev A