Installation guide
Set
Up & Programming
Transmitter Programming - Feature Bank 1
1.
Turn the ignition ON.
2.
Press and hold the valet/override button.
3.
Within 10 seconds the parking lights will flash (3) three times.
4.
Press 1 button
of
each transmitter you wish to program.
5.
The system will respond with 1 light flash for each accepted transmitter.
6.
Pressing the override button at anytime during programming will advance to
the next bank.
NOTE: The system will exit transmitter programming after 15 seconds of inactivity.
NOTE: This system has 1 button programming which programs all channels of the
system.
NOTE: The system will hold up to 4 transmitters
in
memory, programming a 5th
transmitter will erase the oldest transmitter
in
memory.
NOTE: This system has
PTN-
Programmed Transmitter Notification. Each time the
ignition
is
turned ON, the LED will flash the number of transmitters programmed to the
system.
Manual Feature Programming - Feature Bank 2 - 5
1.
Turn the ignition ON.
2.
Press and hold the valet/override button.
3.
Within 10 seconds the parking lights will flash (3) three times.
4.
Use the valet/override button to advance through each option bank. For
feature programming advance to Feature Bank
2,
3,
4 or
5,
which
is
(4)
four, (5) five, (6) six and (7) seven parking light flashes.
5.
Use the transmitter 0 button to scroll through the selections
in
each
feature bank, the parking lights will flash to match the feature number.
6.
Press the BRAKE to change the desired feature. The LED will flash
indicating the changed feature.
NOTE: The system will remain
in
feature programming mode as long as the ignition
is
on, there
is
no time limit.
To
exit programming turn the IGNITION
OFF.
2014 Voxx Electronics Corporation. All rights reserved.
11