Remote Vehicle Control System CA-125 Owner's Manual Vehicle Security System With Remote Keyless Entry IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information.
Table of Contents Using Your Remote Transmitter ...................................... 3 Arming the Security System Pre-arm Mode Disarming the Security System Disabling/Enabling confirmation chirps Attempted Intrusion Identification Using Your Remote Transmitter ......................................
Using Your Remote Transmitter Arming the Security System To arm the system, exit the vehicle, close all doors, then press the LOCK icon button on the transmitter. The horn will honk twice and the parking lights will flash twice, indicating the system is armed. The doors will also lock at this time (if equipped and connected). The status indicator (blue warning light on the dash) will blink steadily, once per second. To arm the system silently, press and hold the LOCK icon button for 1 second.
Using Your Remote Transmitter Two Stage Door Unlock If this feature is enabled on your system, pressing the UNLOCK icon button one time on the transmitter will unlock only the driver’s door. Press disarm again within 15 seconds to unlock the remaining doors. Activating the Trunk Release Feature If this feature is enabled on your system, pressing and holding the TRUNK icon button on the transmitter for 2 seconds will open the vehicles trunk or hatch.
Automatic Convenience Options Illuminated Entry When the system is UNLOCKED, the vehicle courtesy lights will turn on for 1 minute, or until the vehicle is started or the system is re-locked. Automatic Arming If this feature is enabled on your system, the security system will arm automatically 1 minute after the ignition key is turned off and the last vehicle door is closed. The dash mounted status LED will flash rapidly indicating the 1 minute countdown.
Optional Songbird Feature The optional songbird feature (Code Alarm part # SB1 and labor required) allows you to program songs and tones to your system (i.e. Setting a different tone for Lock activation and unlock activation). Turning Songbird On: Press and release the TRUNK icon button on the remote control, then press and hold the LOCK icon button on the remote control within 2 seconds. The SB1 speaker will give notification that Songbird has be turned ON.
Emergency Override Procedure If your transmitter is lost or disabled, it will be necessary use the emergency override button to turn the security system off. There are two types of emergency override procedures. Check with your installing dealer to find out what has been activated on your system. Standard Emergency Override Procedure 1. Enter the vehicle (the security system will trigger. 2. Turn the ignition key to the ON position. 3.
Code Systems, Inc. Limited Lifetime Warranty A Code Systems Inc. (“CODE”) vehicle comfort, convenience and security system sold to a retail consumer purchaser by an authorized dealer of CODE and installed by an authorized dealer of CODE is warranted by CODE to the original retail consumer purchaser to be free from defects in workmanship and materials for the lifetime of the vehicle in which the system was originally installed.
