Remote Vehicle Control System CA-130 TM Owner's Manual Security and Convenience System IMPORTANT NOTE: The operation of the Securityand Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information. CA 130 owners rev 7-04.
Table of Contents Features and Benefits of the Code Alarm CA-130TM ....................... 3 Using Your Remote Transmitter .............................................. 4 Arming the Security System Pre-arm Mode Disarming the Security System Attempted Intrusion Identification Disabling the IT-sTM Interior Theft Sensor ...............................
Features and Benefits of the Code Alarm CA-130TM Two Easy-to-Use Weather-Resistant Remote Controls The remote controls included with the Code Alarm CA-130TM utilize durable, moisture resistant cases and sealed rubber buttons for reliability and long life. Rolling code technology prevents the transmitter signals from being duplicated. The button functions are clearly labeled to make the Code Alarm CA-130TM simple to operate.
Using Your Remote Transmitter LOCK Button UNLOCK Button Press to Arm Security System and Lock Doors Press to Disarm Security System and Unlock Doors Press and Hold to Activate Aux 1 Press Twice for TwoStage Door Unlock* Press LOCK and UNLOCK Together to Activate Aux 3 Press and Hold to Open Trunk FIND/PANIC Button LIGHTS Button Press for Car Finder Press to Turn Headlights ON Press and Hold for Panic Alarm Arming the Security System Press LIGHTS and FIND/PANIC Together to Activate Aux 4 To
Using Your Remote Transmitter (cont.) Disabling the IT-s Interior Theft Sensor It may be necessary at times to disable the IT-s Interior Theft Sensor, especially when parking in areas (like parking garages) where extreme vibration may cause false alarms. Press the LOCK button and then press the FIND/PANIC button within two seconds of pressing LOCK to disable the interior theft sensor. The siren will chirp two times to indicate that the sensor is disabled.
Using Your Remote Transmitter (cont.) Using Valet Mode If the Passive Arming feature is enabled on your system, Valet mode temporarily prevents the alarm system from arming automatically. This is useful when fueling or servicing your vehicle. To enter Valet Mode: With the vehicle ignition key in the ON position, press the LOCK and UNLOCK buttons simultaneously. The blue dashboard warning light (status indicator) will turn on for one second, then turn off. This indicates that the system is in Valet mode.
When your Security System Is Triggered The Code Alarm CA-130TM will trigger if one of the following events occurs while the system is armed: • Any protected entrance is opened • The vehicle ignition is turned on • The vehicle is jolted hard enough to signal the impact sensor Once the alarm is triggered, the siren (or horn) sounds and the vehicle parking lights flash for 30 seconds. The system will then rearm, awaiting the next intrusion attempt.
System Maintenance (cont.) Adding Remote Controls to Your System The Code Alarm CA-130TM has the ability to operate from up to eight (8) remote controls. Follow these instructions to add a remote control to your system. 1. Make sure the security system is disarmed and the ignition is off. 2. Open the driver’s door. 3. Turn vehicle ignition on. 4. Press and hold the emergency override button. After 10 seconds, the siren or horn will sound three (3) times.
Emergency Disarm OverrideProcedure Procedure If your remote control is lost or fails to function, use this procedure to disarm the Code Alarm CA-130TM and start your vehicle. 1. Use the keys to enter the vehicle. The alarm will sound once the door is opened. 2. Insert the key into the ignition and turn to the ON position. 3. Locate and press the emergency override button. The alarm will turn off and then you will be able to start your vehicle.
Basic Troubleshooting This section outlines some of the basic issues you may experience while becoming used to the Code Alarm CA-130TM. If you have a problem that is not covered by this section, please consult your installer.
Personalized Transmitters Option A. What is Personalized Transmiiters option Personalized Transmmiter’s when selected will active an auxilary when the unit recieves an unlock command from the tranmitter. This function would be used to activate memory seats or any other device that you wanted activated when unlocked . B. How do Personalized Transmitters work? Any Transmitter’s that are learned as #1 will Activate (AUX) Three (3).
Code Systems, Inc. Limited Lifetime Warranty A Code Systems Inc. (“CODE”) vehicle comfort, convenience and security system sold to a retail consumer purchaser by an authorized dealer of CODE and installed by an authorized dealer of CODE is warranted by CODE to the original retail consumer purchaser to be free from defects in workmanship and materials for the lifetime of the vehicle in which the system was originally installed.
Code System, Inc. Theft Protection Guarantee The Theft Protection Program is designed to provide the retail purchaser of a security system provided by CODE-ALARM, INC. (“CODE”) an additional benefit, at no additional cost to the purchaser, should their vehicle be stolen while protected by a CODE-ALARM security system.
CA 130 owners rev 7-04.
