User`s manual

19 19

External Power Sources

Battery Pack

The battery pack is an external, rechargeable, lead acid battery pack than can be used as an

additional, long-life, portable, external source of power. It is rechargeable by plugging the AC

Adapter into the recharging port. The battery pack is connected to the pump via the two-hole

port located on the bottom of the pump (as shown below). The two-pin connector plugs into the

receptacle correctly by aligning the red dots on each.

Note: Pause the pump and then turn it off before connecting the Battery Pack. Note also that

the connector is keyed with a “notch” at this red-dot location to guide alignment. To remove, pull

back on the locking sleeve to unlock and then pull gently to remove the connector from the

pump’s port.

Figure 1.12 Battery Pack

Introduction

o charge the Battery Pack:

Plug the AC Adapter into a grounded wall outlet

and then plug the AC Adapter into the

recharging port of the Battery Pack (see above).

On initial use, the Battery Pack should be

charged for a full 24 hours, subsequent recharge

takes approximately 12 hours (overnight).

Locking Sleeve

Recharging Port

Illustration of the

bottom of the Curlin

Medical Pump

Align the red

dots and the

notches. Then

plug the two-

pin connector

into the two-

hole receptacle

located on the

bottom of the

Curlin Medical

pump.