User`s manual

Reviewing or Changing the Program

To review or make any changes in the prescription programming, press the “NO/CHANGE”

key at the Run Options screen, and the prescription screens will reappear (Changes may be

inhibited by lock setting.) Changes to the prescription can be made before the start of the

therapy; however, once a therapy has started, no changes can be made to the Pre-Prescription

Screen. It will appear only for review purposes. Attempts to change the Pre-Prescription Menu

during a new program review will cause an alert screen to be displayed, notifying the programmer

that changes will require reprogramming of the prescription.

Starting the Infusion

RUN: When all parameters are correct and the pump has been primed properly and connected

to the access site, press “RUN” on the Run Options screen to start the therapy. If a delayed start

is programmed, the “Delay Start Count Down Screen” will appear. If no delay start is

programmed or the delay has elapsed, the pump will begin infusing and the following screen

displays the status of the therapy:

Intermittent Run Screen

This screen continues to display as long as the infusion is in progress. Notice the information

given in each field.

1 The first field displays the “RATE” of the infusion in whichever units/hour has been

selected. The dose number in progress of the total number of doses programmed toggles

with the infusion rate.

2 The second field is a graphic representation of the delivered amount of the dose in progress

or that of the KVO cycle in progress. In CMS-enabled pumps, the graphic bar will

toggle with Line Pressure (“L Press”) which displays the current patient side

(downstream) pressure in the administration set in millimeter of mercury (mmHg)

units.

3 The third field toggles to give Total Volume Infused, Dose Infused, and, if units are mg or

mcg, the Total Amount Infused also.

4 The fourth field gives the remaining time for the entire infusion (all doses in this IV bag), the

remaining amount (in mg or mcg), the remaining volume, and the time the next dose is due.

5 In addition to the display screen accumulating information regarding the status of the

infusion, the green LED light blinks whenever the pump is infusing.

The information on the run screen will alternate between a four-line display and a large-font

display of each individual line of information on the screen.