User manual

ManualsBrandsCode Alarm ManualsAutomotive4000

CONCEPT 3OOO & Access 4000.CONCEPT 3OOO & Access 4000.

CONCEPT 3OOO & Access 4000. User Manual.

PIN CODE

Any User who is required to perform any

operations via a Terminal Keypad will need a PIN

(Personal Identification Number).

If changing a code, Press <OFF> first to clear the

screen. Enter a PIN number using the <DIGIT>

keys. The PIN may be 1 to 8 digits long, however

a minimum of 4 digits is recommended if the PIN

code is to control Areas or access external doors.

(The system may also be configured to force all

PIN Codes to be 6 digits. V5.27 or later only)

When complete: <OK> key to move on to the

“Card Type” question for this User.

<UP> key to program the previous User’s “PIN”.

<DOWN> key to program the next User’s “PIN”.

CARD TYPE.

Any User who is required to perform operations

with an access card must have their card details

entered, beginning with the “Card Type”.

Press the <RIGHT> Arrow key to scroll through

the list until the name of the appropriate Card

Type is displayed. (If you need to return to the

start of the list at any stage, press the <OFF> key)

When complete: <OK> key to move on to the card

details question/s for this User.

<UP> key to edit the previous User’s “Card Type”.

<DOWN> key to edit the next User’s “Card Type”

The next display will depend on the “Card Type”:

i) Credit Card. For credit cards etc. or other non-

Site Code magnetic stripe formats.

ii) Site Code. For Wiegand formats utilizing a

Site Code, or Inner Range magnetic stripe

cards with Site Code format.

iii) Direct Entry. For Wiegand cards where the

Site Code and/or Format is unknown.

User 00009User 00009

User 00009

PIN No.PIN No.

PIN No.

User 00009User 00009

User 00009

PIN No. 2580PIN No. 2580

PIN No. 2580

- - -

U00009 Crd Typ->U00009 Crd Typ->

U00009 Crd Typ->

Credit CardCredit Card

Credit Card

NOTE: The “Card Type” used

in your system should be

recorded in the “System

Details” inside the Front cover.

If not recorded, consult the

Installer for details.

See NOTE below.

or or