User manual

ManualsBrandsCode Alarm ManualsAutomotive4000

CONCEPT 3OOO & Access 4000.CONCEPT 3OOO & Access 4000.

CONCEPT 3OOO & Access 4000. User Manual.

Turning Area/s ON.

Logon to the Terminal as described earlier.

(PIN code + <OK>)

After the greeting (if enabled), the display will show

the Area Status etc. as before. If you are allowed to

control more than one Area, the DISPLAY MODE

can be changed and AREA/S SELECTED as

described in “Turning Area/s OFF”.

At the “Push ON” prompt, turn the displayed Area

(or Area List) ON by pressing the <ON> key.

After the <ON> key is pressed, the system will test

the state of all the inputs allocated to the Area to

ensure that they are in the Sealed condition and the

Area is ready to be turned ON.

THEN:

If all Zones programmed to be tested are Sealed, the

Area will turn ON and this display will indicate that

the operation was successful.

While this message is displayed, you can press the

<ON> key again to view the Exit delay time counting

down in 5 second increments.

Remember: You have a limited time to exit the Area

once you have turned it ON. (Usually 30-90

seconds). Ask the Installer for the Exit time used in

your system.

When the operation is complete the display will

return to the Area status message.

CONFERENCE ROOMCONFERENCE ROOM

CONFERENCE ROOM

is Off. Push Onis Off. Push On

is Off. Push On

CONFERENCE ROOMCONFERENCE ROOM

CONFERENCE ROOM

now Onnow On

now On

Testing ZonesTesting Zones

Testing Zones

Please wait....Please wait....

Please wait....

Display briefly shows:

CONFERENCE ROOMCONFERENCE ROOM

CONFERENCE ROOM

is On. Push Offis On. Push Off

is On. Push Off

Display briefly shows:

then:

- ,

IMPORTANT NOTE: Some systems in high security applications may have the Area

Pre-Arm “Walk Test” feature enabled. (Only available in V3 or later).

In most systems this feature is not enabled and the Area ON procedure will simply be

performed as described below.

If Walk Testing is enabled on your system, the same procedure is followed except that

after the initial test to ensure that all Zones are Sealed, the system then enters Walk

Test mode. Refer to “Area Walk Testing” on the following page.

CONFERENCE ROOMCONFERENCE ROOM

CONFERENCE ROOM

Exit = 035 secExit = 035 sec

Exit = 035 sec