System information
ATS 2000/3000/4000/4500 Programming manual 89
0900: ARITECH , (*) - Next
Text No:
0900: ARITECH , (*) - End
A
RITECH
0900: ARITECH , (*) - End
ARITECH SALES_
10. PROGRAM TEXT
The ATS control panel uses a library of pre-programmed words that are used when
programming the names or texts into the system (e.g.: zone names, area names, etc.).
These words form part of the variable text that appears on the LCD display.
All the words in the library are identified by a reference number, which ranges from 001 to
899. See Table8 7: Word library (page 90) for the list of pre-programmed words available.
Not all words can be in the library. Therefore an additional 100 words can be programmed
freely. The menu Program text is used to add these new words to the ATS library. Words are
considered any combination of 16 characters. They can include numbers, spaces (making
two words for one reference number), or punctuation.
10.1. Program text words
When programming text, first select the reference number to use (900 – 999). If words
are already programmed, press [MENU*] to go through the list. Select the number to
program.
When the number is selected, the word
already programmed is shown and can be
changed. Press [ENTER] to move to the next
character.
To change a character, select it by pressing the correct number button (see Figure 1). To
accept the character, press [ENTER]. The maximum length of text is 16 characters.
Once the text is correct, press [MENU*] to
accept the text. It will be shown to confirm.
Press [MENU*] again to accept the text.
To delete a character, select a whitespace character (under [9], see Figure 1 (page 90).
How to access customised text
Press one of these keypad buttons to:
[MENU*] Scroll through the list of programmable words 900 to 999.
[ENTER] Return to the Programming menu.
? [ENTER] Enter the reference number of the customised word you
want to change/add.
How to program or modify text
Press one of these keypad buttons to:
? [ENTER] Enter each letter and press [ENTER] to move to the next
position.
[MENU*] Save and display the word. All characters from the position
the cursor is at and onwards are deleted.
[MENU*] Press [MENU*] again to exit the display and return to the
first word in the programmable list.