System information

ATS 2000/3000/4000/4500 Programming manual 79
No
–
EE confirm disable (ACPO 2002)
* - Change 0 - Skip
No
–
Eng. Reset on B Alarm only
* - Change 0 - Skip
Y
ES
–
Installer Dual Code
*-Change 0-Skip
Enter Second Code
Code:
Y
ou Are Not Authorised To Ente
r
Press ENTER
Y
ES
–
NFA2P
*-Change 0-Skip
YES – Enable Buzzer on Mains/Line Fault
*-Change 0-Skip
YES – Enable Call Central Station
*-Change 0-Skip
7.48. EE confirm disable (ACPO 2002)
When this option is set, all alarms triggered within the entry time, provided an entry/exit
zone is triggered first, will be dealt with as an “A” alarm. They will not be reported to the
CS before the entry time has elapsed. Any zone triggered after the entry time has
elapsed will be reported as an “A” alarm only.
 AB alarm option must be set to Yes in the area database.
Option 19.7.47 ACPO 2002 must also be set to Yes.
7.49. Engineer reset on B Alarm only
When this option is set, you do not need an engineer reset when only an “A” alarm has
been triggered
 AB alarm option must be set to Yes in the area database.
Engineer reset for alarm must be set to Yes in zone database and system option.
7.50. NFA2P
Sets sets the panel to comply with the NFA2P requirement.
7.51. Installer dual code
If this option is YES, then a second user code must be entered before access to the
installer menu is granted. The second code must be a valid user code with no access to
the installer menu.
The second user must have Alarm System Control and not have access to menu 19. If
the second user does not meet these conditions, then the display will show:
When ‘Enter’ is pressed, the display will return to the user menu.
7.52. Enable Buzzer on Mains/Line fault
YES Keypad buzzer will be sounded when there is a mains/line fault.
NO Only the LED will flash.