System information

ATS 2000/3000/4000/4500 Programming manual 71
NO
–
System Alarms Set Siren & Strobe
*-Change 0 - Skip
NO
–
Latching System Alarms
*-Change 0 - Skip
NO
–
Test Siren
*-Change 0 - Skip
NO
–
Disable 0 ENTER For Camera Reset
*-Change 0 - Skip
 See also the manager guide regarding programming users.
7.14. System "Tamper" activates siren
and strobe
Indicate whether system tampers should activate siren and strobe.
YES The dedicated tamper zones on the ATS control panel and the DGP’s activate
the siren and strobe when in alarm.
NO The system alarms report and activate event flags (if programmed) only.
 Press 0 to skip further options and leave system options.
7.15. Latching system alarms
System alarms are RAS/DGP Offline, cabinet tamper, siren tamper, mains fail, fuse fail,
low battery, etc.
YES System alarms latch and require a code to reset. If set to YES, ensure that
users who have the appropriate authority are assigned an alarm group that has
"Reset System Alarms" set to YES.
NO System alarms automatically reset and report restoral when the alarm condition
is no longer present.
 Press 0 to skip further options and leave system options.
 Remember to program the users alarm group with “Reset system alarms” set to
YES. See Alarm groups on page 51.
7.16. Siren testing
Enable a siren test when the arm test is started.
YES The sirens are tested for three seconds when the arm test is started.
NO Sirens are not tested when the arm test is started.
 Press 0 to skip further options and leave system options.
 See Test mode in System options on page68.
7.17. Disable "0 ENTER" for camera
reset
Defines the procedure to stop cameras from operating. See the Manager’s guide for more
information.