System information

ATS2000/3000/4000/4500 Programming manual
70
NO
–
Auto Uninhibit When Area Disarmed
*-Change 0 - Skip
NO
–
Display One Zone at a Time
*-Change 0 - Skip
Y
ES
–
Username File
*-Change 0 - Skip
YES Dual zone used: Normal = 4k7; Tamper = Open or Short; Active = 2k35 or 9k4.
NO No dual zone; Normal = 4k7; Alarm = Open or Short or 2k35 or 9k4.
 Press 0 to skip further options and leave system options.
 End of line resistors have to be connected to the zone. See the installation guide.
7.11. Automatic uninhibit
Determine if zones are automatically uninhibited if the area is disarmed. However, this
option is only valid if the alarm group allows automatic uninhibit.
YES Zones in normal state and inhibited are uninhibited when any of the areas
assigned to the zone are disarmed. This is done to ensure that inhibited zones
are not ignored or overlooked.
NO Zones in normal state and inhibited are not uninhibited when any of the areas
assigned to the zone are disarmed.
 Press 0 to skip further options and leave system options.
 See also Alarm groups on page 51.
7.12. Display zones
This record controls the way zone names and numbers are displayed on the LCD during
user functions.
YES One zone at a time is displayed even though there may be more than one in
the list of zones to be displayed. The user must scroll through the zones. eg.
Active 2. Building 1 Workshop PIR.
NO Zones are displayed as a list of numbers and it is necessary to select the zone
number to display the individual zone name. eg. Active 1, 2, 3.
 Press 0 to skip further options and leave system options.
7.13. User name file
Determines if users have names with their PIN codes programmed. Only users 1 – 200
can have a name with their PIN code (if memory extension available).
YES The appropriate prompts for programming a username, are displayed when
programming user codes.
NO The appropriate prompts for programming a username, are not displayed when
programming user codes.
 Press 0 to skip further options and leave system options.