Manualshelf

System information

ManualsBrandsCode Alarm ManualsAutomotive4000
61626364656667686970
ATS2000/3000/4000/4500 Programming manual
64
Door(s) Unlock Time (Sec). 5
Time:
Individual Testmode Time (Min). 5
Time:
Testing Event Flag Time (Sec). 15
Time:
External Siren Set to (Min)
Time:
Internal Siren Set to (Min)
Time:
Siren Delay Set to (Min)
Time:
See Area database on page 36 and the Manager’s guide, local alarms, for further
information
6.16. Individual zone test time
Enter the maximum time (0 – 255 minutes) to perform a test on an individual zone, using
user menu 12, Test zone.
See the Manager guide, user menu 12. Test zone for more information.
6.17. Door(s) unlock time
The time doors will unlock (using the door event flag) in order to allow doors to be
opened. This time value is common for all door event flags from RAS’s connected to the
ATS system, i.e. doors 1 to 16. Doors 17 – 64 are connected to ATS1250/1260
4-DoorDGP’s that are individually programmed in the DGP.
See also RAS database on page 42.
6.18. Testing event flag time
Specify the time the testing event flag is triggered to activate devices in order to perform
an arm test. The event flag will only be triggered for half the programmed time. The
remaining time is used to allow the device to switch back to normal state.
The event flag used is preset to 16.
More on event flags in Event Flags on page 151.
6.19. External siren set to.
This option specifies the amount of time (0 – 255 minutes) that the on-board external
siren drivers activate. The maximum time is 255 minutes.
See Zone database (page 17) and Area database (page 36) for more information
6.20. Internal siren set to
This option specifies the amount of time (0 – 255 minutes) that the on-board internal siren
drivers activate. The maximum time is 255 minutes.
See Zone database (page 17) and Area database (page 36) for more information
6.21. Siren delay set to
This option allows you to set the delay time ( 0- 255 minutes) before the sirens actually
activate after an alarm has occurred. This can be used for recording any sounds before
the siren activates.
The siren delay is set to 0.