System information

ATS 2000/3000/4000/4500 Programming manual 43
RAS: 2 Has No Door Event Flag
Event Flag:
RAS: 3 Can See Output Controller 1
Output Ctrl:
Y
ES
–
LCD Arming Station
* - Change 0 - Skip
3.2.3. Door event flag
If a door has to be unlocked using the RAS, enter the event flag here. The event flag can
be assigned to an output and will be activated when a valid code is entered at the arming
station.
What is recognised as a valid code for unlocking the door depends on the setting in
ENTER key opens door only (page 45), and Alarm code prefix (page 69)
3.2.4. Output controller assigned
Keypads with card reader interfaces have an output OUT. To be able to control the
output, an output control group has to be assigned to the RAS. The first output on the
output controller is also the OUT output from the RAS. Whenever the first output is
activated, the OUT output is also activated.
The output control group entered here does not need to be physically available.
 If two RAS’s have the same output control group and the user has both doors in his
doorgroup, both relays will be switched simultaneously.
3.2.5. LCD arming station
YES This arming station is a LCD arming station. This has to be set in order to be
able to operate LCD arming stations.
NO This is not a LCD arming station.
See Table 3 on page 44 for further information on options available to arming stations.