System information

ATS2000/3000/4000/4500 Programming manual
40
Out Of Hour Timezone: 0
Enter Tz:
A
rea Disarmed Time: 0 Mins
Enter Mins:
Y
ES
–
Report To CS1
* - change, 0 - Skip
Y
ES
–
Report To CS2
* - change, 0 - Skip
Y
ES
–
Report To CS4
* - change, 0 - Skip
A
rea 1 Alarm-
A
No Event Flag
Event Flag:
A
rea 1 Alarm-B No Event Flag
Event Flag:
Y
ES
–
Report To CS3
* - change, 0 - Skip
2.1.19. Alarm A event flag
Used to generate an event linkable to a relay output to primarily support the Red Care
communications unit in the UK. This event flag follows the ‘A’ event generated by the AB
alarms as sent to the central station event out queue.
2.1.20. Alarm B event flag
Used to generate an event linkable to a relay output to primarily support the Red Care
communications unit in the UK. This event flag follows the ‘A’ event generated by the AB
alarms as sent to the central station event out queue.
2.1.21. Out-of-hours timezone
Used to generate a report if the area is disarmed while the area should be armed. The
message is reported depending on the type of transmission protocol.
2.1.22. Area disarmed time
When using alarm group restrictions, one of the options available is to disarm an area for
a disarmed period. If the Area Disarmed time is not ‘0’, then this time will be used. See
Alarm group restrictions on page 98.
 If the Disarmed time for the Alarm group Restriction is set to 0, to specify that the
area will not re-arm, the "Area Disarmed Time" does apply for that area (see
Timers on page 61 for more information).
2.1.23. Report to Central Station 1
YES Report opening/closing and Late to Close to Central Station 1.
NO Do not report to Central Station 1.
2.1.24. Report to Central Station 2
See Report to Central Station 1.
2.1.25. Report to Central Station 3
See Report to Central Station 1.
2.1.26. Report to Central Station 4
See Report to Central Station 1.