System information

ATS2000/3000/4000/4500 Programming manual
28
1.1.7. Report Alarm to Central Station 4
See Report Alarm to Central Station 1.
1.1.8. Enable Audio Listen-in for this zone
When YES is selected, this zone allows for audio listen-in on alarm.
YES Audio Listen in enabled for this zone.
NO No Audio Listen in.
1.1.9. Enable engineer reset for alarms
Select YES to enable engineer reset for alarm in this zone. The user can not arm the
area the zone belongs to, until an engineer reset has been performed.
YES Engineer reset enabled for alarms in this zone.
NO No engineer reset.
 How to perform an engineer reset.
Whenever an engineer reset is required, the panel will display a 4-digit code. This
code is a reference to a special code that can be found in the TITAN software
package (menu control) or contact your local Aritech distributor.
1.1.10. Enable engineer reset for tamper alarms
Select YES to enable engineer reset for alarm in this zone. The user can not arm the
area the zone belongs to, until an engineer reset has been performed.
YES Engineer reset enabled for tamper alarms in this zone.
NO No engineer reset.
 How to perform an engineer reset
Whenever an engineer reset is required, the panel will display a 4-digit code. This
code is a reference to a special code that can be found in the TITAN software
package (menu control) or contact your local Aritech distributor.
1.1.11. Disable inhibit of the zone
If users are allowed to inhibit the zone, select NO.
YES No inhibit allowed.
NO This zone can be inhibited.
YES - Report To CS4
* - change, 0 - Skip
NO – Enable Audio Listen In
* - change, 0 - Skip
NO – Engineer Reset on Alarm
* - change, 0 - Skip
NO – Engineer Reset on Tamper
* - change, 0 - Skip
NO – Disable Inhibit
* - change, 0 - Skip