System information

ATS2000/3000/4000/4500 Programming manual
152
Event Name Description
1 Internal/External
Siren
Default Internal/External siren event flag (assigned in area
database).
If set to YES in the zone database, activates when any
Internal/External siren activates in any area.
2 Armed Alarm If set to YES on the zone database, activates when an alarm is
generated by the zone and all the areas assigned to the zone are
armed. It is used to activate the system strobe.
3 Armed Alarm As event flag 2
4 Armed Alarm As event flag 2
5 Armed Alarm As event flag 2
6 Disarmed Alarm If set to YES in the zone database, activates when an alarm is
generated by the zone and one or more of the areas assigned to
the zone are disarmed.
7 Disarmed Alarm As event flag 6
8 24 Hour Alarm If set to YES in the zone database, activates at any time an alarm
is generated by the zone.
9 Armed Alarm As event flag 2
10 Armed Alarm As event flag 2
11 Armed Alarm As event flag 2
12 Armed Alarm As event flag 2
13 Disarmed Alarm As event flag 6
16 Testing Activates during the arm test. A testing event is used to activate a
device that allows the testing of other devices that need to be
tested. For example activate a light to test a light detector.
The tester event flag activates for half the “Testing event flag”
programmed in Programming menu 6, Timers. The remaining
period of the arm test time is settling time to allow the tested
device to switch back to normal state.
i.e. Make sure that the arm test time is longer than the testing
event time.
More about event flags?
For the usage of event flags, see the sections concerning:
• Menu 1, Zone database on page 17
• Menu 2, Area database on page 36
• Menu 3, RAS database on page 42
• Menu 16, Event to output on page 104
• Menu 21, Zone shunts on page 111
• Menu 28, To Remote Devices (4-door DGP and 4-lift DGP) on page 119 and the
programming guide concerning the appropriate remote controller.
• Menu 34, Program system event flags on page 130
• Menu 35, Program macro logic on page 134