System information

ManualsBrandsCode Alarm ManualsAutomotive4000

141

142

143

144

145

146

147

148

149

150

ATS 2000/3000/4000/4500 Programming manual 149

Test not completed

Press ENTER

Test completed

Press ENTER

Test not completed

Please wait

 Note: The warning timer functions as normal during this test. That is, a warning will

sound (if warning time programmed) in the normal fashion.

Otherwise, once all zones have been tested successfully a message ‘Test Complete’ is

displayed, and a message is sent to the central station (see events logged table below).

If the Clear key is pressed while the test is running, ‘Please wait’ display shown below is

displayed while the aux output is pulsed (described further below). When the aux output

pulsing is completed, the walk test will be exited automatically to the install menu.

At the end of the walk test, the walk test event flag will be deactivated.

The test will cause the following events to be logged. These events are sent as messages to

the central monitoring station:

Event logged When logged

ACCESS_TEST_STARTED

When test started

WALK_TEST_ZONE_TESTED

When a zone is tested and Titan is connected to

the panel. (computer connection active event flag

set), Event message includes number of zone

tested.

This event is not sent to central stations.

WALK_TEST_ZONE_NOT_TESTED

When a zone Fails the test and Titan is connected

to the panel. (computer connection active event

flag set) Event message includes number of zone

tested.

This event is not sent to central stations.

ACCESS_TEST_FAILED

If user cancels the test or on test timeout (failed)

ACCESS_TEST_COMPLETED

Test completed successfully

 If Titan is connected to the panel, (computer connection active event flag set), the

“WALK_TEST_ZONE_TESTED” , “WALK_TEST_ZONE_NOT_TESTED”,

“ACCESS_TEST_FAILED” or “ACCESS_TEST_COMPLETED” will be logged in

the panel and send to Titan history.

 If Titan is NOT connected to the panel (computer connection active event flag NOT

set), the “WALK_TEST_ZONE_TESTED” and

WALK_TEST_ZONE_NOT_TESTED” will be Ignored and not logged.Only the

ACCESS_TEST_FAILED or ACCESS_TEST_COMPLETED will be logged in the

panel.

This is to prevent the panel memory from being filled with events when Titan is not

connected

After each walk test (failed, or completed) a new “Engineer Walk Test Reset” system event

flag will be activated for 5 seconds. Users may use this event flag to switch the aux output

(output 251) to reset any latched detectors in alarm.