System information

ATS2000/3000/4000/4500 Programming manual
14
If the programming of the system is done, the system has to be tested. Menus providing
support in testing are:
User menu’s
1. Panel status Provides system information.
2. Active zones Shows zones not in normal state (e.g. active or
tampered).
3. Zones in alarm Shows any zone in alarm.
4. Inhibited zones Shows any inhibited zone.
5. History Lists all events that occured.
6. Test report Use this menu to perform an arm or disarm test.
10. Inhibit zone Inhibit any zone.
11. Uninhibit zone Uninhibit any zone previously inhibited.
12. Test zone Test any individual zone.
13. Start Auto Disarm test Use this menu to perform an auto disarm test.
16. Inhibit/Uninhibit RAS/DGP Inhibit or uninhibit any RAS or DGP.
22. Open door Open a door for the programmed unlock time.
23. Unlock, Lock, Disable or
Enable Doors
Using this menu doors can be unlocked until
locked again with this menu. Disable or enable
doors.
Installer menu’s
11. Version number Verify version numbers for the control panel, any
RAS or DGP.
12. LED test Activate all LED’s on all RAS’s.
14. Reset to Default If required, all settings or only a part can be reset
to factory defaults.
23. Poll errors Use this option to view if communication errors
occured on the system databus.
25. Display card Display the system code and CARD ID when using
the 1-door RAS’s like the ATS1170.