System information

ATS2000/3000/4000/4500 Programming manual
130
Fuse Fail Event Flag
Event Flag:
Low Battery No Event Flag
Event Flag:
Tamper No Event Flag
Event Flag:
Mains Fail No Event Flag
Event Flag:
34. PROGRAM SYSTEM EVENT FLAGS
Event flags are set when specified events occur in the system, such as a mains failure, a
zone generating an alarm or an entry time running.
The system event flags are triggered on system wide events, like mains failures or DGP’s
going offline.
 For more information regarding event flags, see Event Flags on page 151.
34.1 Mains fail event flag
This event flag is activated when a Mains Failure is detected on the ATS control panel or
a DGP.
 Do not use a preset event flag number (1 – 16). Program 0 to disable an event flag.
34.2. Low battery event flag
This event flag is activated when a Low Battery is detected on the ATS control panel or a
DGP.
See also Mains fail event flag.
34.3 Fuse fail event flag
This event flag is activated when a Fuse Fail is detected on the ATS control panel or a
DGP.
See also Mains fail event flag.
34.4 Tamper event Flag
This event flag is activated when a Panel Tamper is detected on the ATS control panel or
a DGP. (includes RAS tampers)
See also Mains fail event flag.